On Thu, May 02, 2024 at 12:09:41PM GMT, Dmitry Baryshkov wrote: > On Thu, 2 May 2024 at 12:04, Komal Bajaj <quic_kbajaj@xxxxxxxxxxx> wrote: > > > > This series adds devicetree nodes to support interconnects and usb for qdu/qru1000. > > This is based on previously sent driver series[1]. > > > > ------ > > Changes in v3: > > * As per comments on upstream[2], to get role-switch working on QDU/QRU1000, it was recommended to > > use the actual TI switch driver. Since driver doesn't have the functionality to provide role-switch > > based on gpio, thus reverting back USB dr_mode to peripheral and removed the remote end-point nodes > > and usb-conn-gpio based role switch functionality. > > This is not correct. The recommendation was to describe hardware properly. > Which means adding schema description, adding ti,your-switch > compatible to the usb-conn-gpio.c driver, etc. > In addition to wrangling the ti,switch implementation (and binding) into something that only deals with the gpios and not actually talks to the chip, this would also require us to add support for fishing out vbus-supply of the connector and control that from said driver (or from dwc3, or from dwc3-qcom...). Given that I find it acceptable to pick up the peripheral-only support as presented... Regards, Bjorn > > * Link to v2: https://lore.kernel.org/linux-arm-msm/20240319091020.15137-1-quic_kbajaj@xxxxxxxxxxx/ > > > > Changes in v2: > > * Changes qmpphy node name > > * Changes dr_mode to otg and added USB-B port USB role switch > > * Dropped maximum-speed property from usb dwc3 node > > * Link to v1: https://lore.kernel.org/linux-arm-msm/20240311120859.18489-1-quic_kbajaj@xxxxxxxxxxx/ > > > > [1] https://lore.kernel.org/linux-arm-msm/20240502082017.13777-1-quic_kbajaj@xxxxxxxxxxx/ > > [2] https://lore.kernel.org/all/CAA8EJppNZrLzT=vGS0NXnKJT_wL+bMB9jFhJ9K7b7FPgFQbcig@xxxxxxxxxxxxxx/ > > ------ > > > > Komal Bajaj (3): > > arm64: dts: qcom: qdu1000: Add USB3 and PHY support > > arm64: dts: qcom: qdu1000-idp: enable USB nodes > > arm64: dts: qcom: qru1000-idp: enable USB nodes > > > > arch/arm64/boot/dts/qcom/qdu1000-idp.dts | 23 +++++ > > arch/arm64/boot/dts/qcom/qdu1000.dtsi | 120 +++++++++++++++++++++++ > > arch/arm64/boot/dts/qcom/qru1000-idp.dts | 23 +++++ > > 3 files changed, 166 insertions(+) > > > > -- > > 2.42.0 > > > > > > > -- > With best wishes > Dmitry
