On Thu, 2 May 2024 at 12:04, Komal Bajaj <quic_kbajaj@xxxxxxxxxxx> wrote: > > This series adds devicetree nodes to support interconnects and usb for qdu/qru1000. > This is based on previously sent driver series[1]. > > ------ > Changes in v3: > * As per comments on upstream[2], to get role-switch working on QDU/QRU1000, it was recommended to > use the actual TI switch driver. Since driver doesn't have the functionality to provide role-switch > based on gpio, thus reverting back USB dr_mode to peripheral and removed the remote end-point nodes > and usb-conn-gpio based role switch functionality. This is not correct. The recommendation was to describe hardware properly. Which means adding schema description, adding ti,your-switch compatible to the usb-conn-gpio.c driver, etc. > * Link to v2: https://lore.kernel.org/linux-arm-msm/20240319091020.15137-1-quic_kbajaj@xxxxxxxxxxx/ > > Changes in v2: > * Changes qmpphy node name > * Changes dr_mode to otg and added USB-B port USB role switch > * Dropped maximum-speed property from usb dwc3 node > * Link to v1: https://lore.kernel.org/linux-arm-msm/20240311120859.18489-1-quic_kbajaj@xxxxxxxxxxx/ > > [1] https://lore.kernel.org/linux-arm-msm/20240502082017.13777-1-quic_kbajaj@xxxxxxxxxxx/ > [2] https://lore.kernel.org/all/CAA8EJppNZrLzT=vGS0NXnKJT_wL+bMB9jFhJ9K7b7FPgFQbcig@xxxxxxxxxxxxxx/ > ------ > > Komal Bajaj (3): > arm64: dts: qcom: qdu1000: Add USB3 and PHY support > arm64: dts: qcom: qdu1000-idp: enable USB nodes > arm64: dts: qcom: qru1000-idp: enable USB nodes > > arch/arm64/boot/dts/qcom/qdu1000-idp.dts | 23 +++++ > arch/arm64/boot/dts/qcom/qdu1000.dtsi | 120 +++++++++++++++++++++++ > arch/arm64/boot/dts/qcom/qru1000-idp.dts | 23 +++++ > 3 files changed, 166 insertions(+) > > -- > 2.42.0 > > -- With best wishes Dmitry
