Re: [PATCH v3] arm64: dts: qcom: qcs6490-rb3gen2: enable hdmi bridge

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, 8 May 2024 at 10:38, Krzysztof Kozlowski
<krzysztof.kozlowski@xxxxxxxxxx> wrote:
>
> On 07/05/2024 21:20, Abhinav Kumar wrote:
> >
> >
> > On 5/7/2024 9:35 AM, Krzysztof Kozlowski wrote:
> >> On 07/05/2024 18:30, Venkata Prahlad Valluru wrote:
> >>> Rb3Gen2 has a lt9611uxc DSI-to-HDMI bridge on i2c0, with
> >>> reset gpio from pm7250b gpio2 and irq gpio from tlmm gpio24.
> >>> Bridge supplies are Vdd connected to input supply directly
> >>> and vcc to L11c. Enable HDMI output, bridge and corresponding
> >>> DSI output.
> >>>
> >>> Signed-off-by: Venkata Prahlad Valluru <quic_vvalluru@xxxxxxxxxxx>
> >>> ---
> >>> v3: - Updated commit text
> >>>      - Arranged nodes in alphabetical order
> >>>      - Fixed signoff
> >>>      - Fixed drive strength for lt9611_irq_pin
> >>>      - Removed 'label' from hdmi-connector, which is optional
> >>
> >> Please respond to each Bjorn comment and explain how did you implement it...
> >>
> >
> > Yes, agreed. Even though it seems like you mostly just agreed to mine
> > and Bjorn's suggestions and decided to implement all those in v3 , it
> > would have been better to explicitly ack them or tell why you agreed or
> > what went wrong that you had not done it in v2 itself to close the loop.
>
> The problem is that one or more were ignored... By responding to each of
> them, I hope they will be finally read and understood instead of
> repeating the same mistake three times.

I found a mistake that was repeated two times. This leaves me
wondering which mistake was repeated three times.


-- 
With best wishes
Dmitry




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux