On 08/05/2024 10:13, Dmitry Baryshkov wrote: > On Wed, 8 May 2024 at 10:38, Krzysztof Kozlowski > <krzysztof.kozlowski@xxxxxxxxxx> wrote: >> >> On 07/05/2024 21:20, Abhinav Kumar wrote: >>> >>> >>> On 5/7/2024 9:35 AM, Krzysztof Kozlowski wrote: >>>> On 07/05/2024 18:30, Venkata Prahlad Valluru wrote: >>>>> Rb3Gen2 has a lt9611uxc DSI-to-HDMI bridge on i2c0, with >>>>> reset gpio from pm7250b gpio2 and irq gpio from tlmm gpio24. >>>>> Bridge supplies are Vdd connected to input supply directly >>>>> and vcc to L11c. Enable HDMI output, bridge and corresponding >>>>> DSI output. >>>>> >>>>> Signed-off-by: Venkata Prahlad Valluru <quic_vvalluru@xxxxxxxxxxx> >>>>> --- >>>>> v3: - Updated commit text >>>>> - Arranged nodes in alphabetical order >>>>> - Fixed signoff >>>>> - Fixed drive strength for lt9611_irq_pin >>>>> - Removed 'label' from hdmi-connector, which is optional >>>> >>>> Please respond to each Bjorn comment and explain how did you implement it... >>>> >>> >>> Yes, agreed. Even though it seems like you mostly just agreed to mine >>> and Bjorn's suggestions and decided to implement all those in v3 , it >>> would have been better to explicitly ack them or tell why you agreed or >>> what went wrong that you had not done it in v2 itself to close the loop. >> >> The problem is that one or more were ignored... By responding to each of >> them, I hope they will be finally read and understood instead of >> repeating the same mistake three times. > > I found a mistake that was repeated two times. This leaves me > wondering which mistake was repeated three times. That was about future, I was expecting v4 as in-reply-to :) Best regards, Krzysztof
