Re: [PATCH v2 8/8] arm64: defconfig: enable interconnect and pinctrl for SM4450

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 16/09/2023 17:13, Georgi Djakov wrote:
>
>>
>> Complete list here, and it is inconsistent. Latest 8550 is also =y. Do we document
>> the reasons somewhere on why they are added as =y?
>>
>> CONFIG_INTERCONNECT_QCOM=y
>> CONFIG_INTERCONNECT_QCOM_MSM8916=m
>> CONFIG_INTERCONNECT_QCOM_MSM8996=m
>> CONFIG_INTERCONNECT_QCOM_OSM_L3=m
>> CONFIG_INTERCONNECT_QCOM_QCM2290=m
>> CONFIG_INTERCONNECT_QCOM_QCS404=m
>> CONFIG_INTERCONNECT_QCOM_SA8775P=y
>> CONFIG_INTERCONNECT_QCOM_SC7180=y
>> CONFIG_INTERCONNECT_QCOM_SC7280=y
>> CONFIG_INTERCONNECT_QCOM_SC8180X=y
>> CONFIG_INTERCONNECT_QCOM_SC8280XP=y
>> CONFIG_INTERCONNECT_QCOM_SDM845=y
>> CONFIG_INTERCONNECT_QCOM_SM8150=m
>> CONFIG_INTERCONNECT_QCOM_SM8250=m
>> CONFIG_INTERCONNECT_QCOM_SM8350=m
>> CONFIG_INTERCONNECT_QCOM_SM8450=y
>> CONFIG_INTERCONNECT_QCOM_SM8550=y
> 
> If the device can boot (to console/initramfs) with =m, we go with that.
> But if something critical like the UART depends on the interconnect
> provider, then we make it built-in.
> 
> On SM8550 for example, we have enabled bandwidth scaling support for QUP
> and that's why it needs to be =y.
> 
> It looks like on SM4450 this should be =y too.

I asked why SM4450 has to be =y and there was no answer. The argument
that SM8450 is a module, is not applicable.

Best regards,
Krzysztof




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux