Re: [PATCH 1/4] clk: qcom: clk-rcg2: Fail Duty-Cycle configuration if MND divider is not enabled.

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Quoting Nikita Travkin (2022-01-07 23:25:19)
> Hi,
> 
> Stephen Boyd писал(а) 08.01.2022 05:52:
> > Quoting Nikita Travkin (2021-12-09 08:37:17)
> I'm adding this error here primarily to bring attention of the
> user (e.g. developer enabling some peripheral that needs
> duty cycle control) who might have to change their clock tree
> to make this control effective. So, assuming that if someone
> sets the duty cycle to 50% then they might set it to some other
> value later, it makes sense to fail the first call anyway.
> 
> If you think there are some other possibilities for this call
> to happen specifically with 50% duty cycle (e.g. some
> preparations or cleanups in the clk subsystem or some drivers
> that I'm not aware of) then I can make an exemption in the check
> for that.
> 

I don't see anywhere in clk_set_duty_cycle() where it would bail out
early if the duty cycle was set to what it already is. The default for
these clks is 50%, so I worry that some driver may try to set the duty
cycle to 50% and then fail now. Either we need to check the duty cycle
in the core before calling down into the driver or we need to check it
here in the driver. Can you send a patch to check the current duty cycle
in the core before calling down into the clk ops?




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux