From: "Ivan T. Ivanov" <iivanov@xxxxxxxxxx> Hi, Patches have been tested on top of Stephen's clock controller patches[1] and recent fixes for chipidea msm glue layer driver posted here[2]. Hardware platform AP8074 DragonBoard. Only gadget mode utilized for now. CV Test Suite engine "Chapter 9 tests" are passing except "Halt Endpoint Test". usbtest driver report following failure: test 13 --> 32 (Broken pipe) ep 81 couldn't set halt, -32 This will be investigated further. Patches could be applied cleanly on top of the usb-3.13-rc1. Regards, Ivan [1] http://comments.gmane.org/gmane.linux.ports.arm.msm/5375 [2] https://lkml.org/lkml/2013/11/11/310 v4 -- * Squashed checkpatch.pl warning fixes patches * Squashed dr_mode refactoring with default mode removal * Dropped patch 10 - usb: phy: msm: Switch clock consumer strings * Fixed comments from review. * Utilize reset-framework for LINK and PHY resets if DT is used. * Added support from second PHY device control. * Ported reset procedure from codeaurora tree for new chipsets v3 -- * In patch 1 - functions for reseting PHY and LINK controller just call platform code if available. * New stuff is: cleaning up unneeded/unused driver state variables * Simplified regulator names. There is no references to these names in tree, so there should not be a problem with this. * Replace the USB specific clock names with the more standard 'core' and 'iface' ... names. * Added devicetree support v2 -- * Fix compilation issue in patch 1 * Separate regulator changes * Merge devm_ related changes to one commit * Drop Lindent patch v1 -- Following patches make initial cleanup of usb phy found in the Qualcomm chipsets. Changes include: * Build time error fix. * Move driver to Managed Device Resource allocation. * Checkpatch warnings and error fixes * Removed usage of global regulators variables. Ivan T. Ivanov (15): usb: phy: msm: Move mach dependent code to platform data usb: phy: msm: Move global regulators variables to driver state usb: phy: msm: Migrate to Managed Device Resource allocation usb: phy: msm: Remove unnecessarily check for valid regulators. usb: phy: msm: Fix checkpatch.pl warnings usb: phy: msm: Replace custom enum usb_mode_type with enum usb_dr_mode usb: phy: msm: Remove unused pclk_src_name usb: phy: msm: Remove HSUSB prefix from regulator names usb: phy: msm: Properly check result from platform_get_irq() usb: phy: msm: Add device tree support and binding information usb: phy: msm: Use reset framework for LINK and PHY resets usb: phy: msm: Add support for secondary PHY control usb: phy: msm: Correct USB PHY Reset sequence for newer platform usb: phy: msm: Handle disconnect events usb: phy: msm: Vote for corner of VDD CX instead of voltage of VDD CX .../devicetree/bindings/usb/msm-hsusb.txt | 78 ++- arch/arm/mach-msm/board-msm7x30.c | 37 +- arch/arm/mach-msm/board-qsd8x50.c | 37 +- drivers/usb/phy/phy-msm-usb.c | 664 +++++++++++--------- include/linux/usb/msm_hsusb.h | 36 +- include/linux/usb/msm_hsusb_hw.h | 6 + 6 files changed, 529 insertions(+), 329 deletions(-) -- 1.7.9.5 -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
