Grant, Please ignore that error message and try to build the martian_dev.ko to match your kernel. If it fails please let us know. Best Regards, Antonio On Mon, Feb 4, 2013 at 9:50 AM, Grant Gao <info@xxxxxxxxxxxx> wrote: > Hi Antonio, > > Thanks for the quick response. > > By the way, when I tried to "make" the binary, I got the following error: > "The martian_dev.ko driver and the complementary helper martian_helper are > for use with kernels after 2.6.20. Use the martian-20080407.tar.gz for > earlier kernels." > > Is there any way to get around that? > > Thanks, > Grant > > > -----Original Message----- > From: Antonio Olivares [mailto:olivares14031@xxxxxxxxx] > Sent: Monday, February 04, 2013 7:48 AM > To: QuadroFX.com > Cc: discuss@xxxxxxxxxxxxx > Subject: Re: Linmodem Driver Help > > Grant, > > scanModem reports that your modem is an LT Modem potentially supported by > Martian Modem drivers, and a possible Modem interrupt and sharing > problem: > > For candidate card in slot 04:00.0, firmware information and bootup > diagnostics are: > PCI slot PCI ID SubsystemID Name > ---------- --------- --------- -------------- > 04:00.0 11c1:044e 1235:044e Communication controller: > LSI Corporation > LT WinModem > > Modem interrupt assignment and sharing: > --- Bootup diagnostics for card in PCI slot 04:00.0 ---- > [ 0.204075] pci 0000:04:00.0: [11c1:044e] type 0 class 0x000780 > [ 0.204090] pci 0000:04:00.0: reg 10: [mem 0xfebffc00-0xfebffcff] > [ 0.204100] pci 0000:04:00.0: reg 14: [io 0xec00-0xec07] > [ 0.204110] pci 0000:04:00.0: reg 18: [io 0xe800-0xe8ff] > [ 0.204165] pci 0000:04:00.0: supports D2 > [ 0.204166] pci 0000:04:00.0: PME# supported from D2 D3hot D3cold > [ 0.204170] pci 0000:04:00.0: PME# disabled > > The PCI slot 04:00.0 of the modem card may be disabled early in a bootup > process, but then enabled later. If modem drivers load but the modem is > not responsive, read DOCs/Bootup.txt about possible fixes. > Send dmesg.txt along with ModemData.txt to discuss@xxxxxxxxxxxxx if help > is needed. > > Predictive diagnostics for card in bus 04:00.0: > Modem chipset detected on > NAME="Communication controller: LSI Corporation LT WinModem " > CLASS=0780 > PCIDEV=11c1:044e > SUBSYS=1235:044e > IRQ=14 > HDA2=00:1b.0 > IDENT=Agere.DSP > > For candidate modem in: 04:00.0 > 0780 Communication controller: LSI Corporation LT WinModem > Primary device ID: 11c1:044e > Support type needed or chipset: Agere.DSP > > Download the following file: > > http://linmodems.technion.ac.il/packages/ltmodem/kernel-2.6/martian/martian- > full-20100123.tar.gz > > copy to your linux partition > then run > $ tar -zxvf martian-full-20100123.tar.gz if the 'z' option gives error > remove it and try it again. > $ cd martian-full-20100123 > > If there is a file Agere.txt , please read it since you have 64 bit version > of linux installed, the commands are a bit different. If you need some help > please write back. > > Best Regards, > > > > Antonio > > On Sun, Feb 3, 2013 at 10:39 AM, QuadroFX.com <info@xxxxxxxxxxxx> wrote: >> Hi there, >> >> I am excited to stumble upon your website, and thankful for everyone's > generous helps. >> >> Please see the attached file for detail. >> >> I look forward to the results. >> >> Thanks! >> >> Grant >> >> >
