James, I am not sure if I understand your question correctly, but why do you need gnome-network-admin_22.2??? Do you have wvdial installed.? I believe that is all you might need to see if the modem is correctly installed. Regards, Antonio On 8/3/09, J.N. <jimn1547@xxxxxxxxxxxx> wrote: > Please tell me what I need to get modem going. I downloaded 3 network > admin,only gnome-network-admin_2.22.2-Oubuntu 3_i386.de b would work > Can't get modem code from local group. > ----- Original Message ----- > From: "Antonio Olivares" <olivares14031@xxxxxxxxx> > To: "J.N." <jimn1547@xxxxxxxxxxxx> > Sent: Monday, August 03, 2009 3:26 AM > Subject: Re: James Nunnelley USA kernel 2.6.28-11-generic > > >> On 8/3/09, J.N. <jimn1547@xxxxxxxxxxxx> wrote: >>> hcflimodem package : on site doesn't list the driver package you >>> show...7.80.02.02 full .. not there....1.19full & rest of numbers >>> &letters same..... is that ok? ....... install instructions stopped >>> at: >>> sudo wvdialconf/etc/ wvdial.conf says: "no command found" >> >> Guess it is ok! >> >> http://www.linuxant.com/drivers/hcf/full/archive/hcfpcimodem-1.19full/hcfpcimodem_1.19full_k2.6.28_11_generic_ubuntu_i386.deb.zip >> >> 2.6.28-11-generic >> hcfpcimodem_1.19full_k2.6.28_11_generic_ubuntu_i386.deb.zip 611K >> c89180b2296f3a04b2ec481b178b160b >> >> Is wvdial installed on your system? ModemData.txt is from older >> version of scanModem : >> >> -------------------------- System >> information ---------------------------- >> CPU=i686, >> Linux version 2.6.28-11-generic (buildd@palmer) (gcc version 4.3.3 >> (Ubuntu 4.3.3-5ubuntu4) ) #42-Ubuntu SMP Fri Apr 17 01:57:59 UTC 2009 >> scanModem update of: 2009_05_12 >> >> There are no blacklisted modem drivers in /etc/modprobe* files >> Potentially useful modem drivers now loaded are: >> >> >> If a USB modem or cellphone is attached and was not detected, please >> provide available information in your request to discuss@xxxxxxxxxxxxx >> >> For candidate card in slot 01:0e.0, firmware information and bootup >> diagnostics are: >> PCI slot PCI ID SubsystemID Name >> ---------- --------- --------- -------------- >> 01:0e.0 127a:1003 0e11:b0bc Serial controller: Rockwell International >> HCF 56k Data/Fax Modem >> >> Modem interrupt assignment and sharing: >> --- Bootup diagnostics for card in PCI slot 01:0e.0 ---- >> [ 1.255197] pci 0000:01:0e.0: reg 10 32bit mmio: >> [0xfebf0000-0xfebfffff] >> [ 1.255248] pci 0000:01:0e.0: PME# supported from D0 D3hot D3cold >> [ 1.255258] pci 0000:01:0e.0: PME# disabled >> [ 3.576788] serial 0000:01:0e.0: PCI INT A -> GSI 22 (level, low) -> >> IRQ 22 >> [ 3.576806] serial 0000:01:0e.0: PCI INT A disabled >> >> The PCI slot 01:0e.0 of the modem card may be disabled early in >> a bootup process, but then enabled later. If modem drivers load >> but the modem is not responsive, read DOCs/Bootup.txt about possible >> fixes. >> Send dmesg.txt along with ModemData.txt to discuss@xxxxxxxxxxxxx >> if help is needed. >> >> The newer scanModem outputs if one has wvdial utility or not. I hope >> this helps. >> >> Regards, >> >> Antonio >>> ----- Original Message ----- >>> From: "Antonio Olivares" <olivares14031@xxxxxxxxx> >>> To: <jimn1547@xxxxxxxxxxxx> >>> Cc: <Discuss@xxxxxxxxxxxxx> >>> Sent: Thursday, July 30, 2009 7:33 PM >>> Subject: Re: James Nunnelley USA kernel 2.6.28-11-generic >>> >>> >>>> James, >>>> >>>> scanModem reports that you need hcfpcimodem drivers from linuxant. >>>> >>>> Predictive diagnostics for card in bus 01:0e.0: >>>> Modem chipset detected on >>>> NAME="Serial controller: Rockwell International HCF 56k Data/Fax Modem " >>>> CLASS=0700 >>>> PCIDEV=127a:1003 >>>> SUBSYS=0e11:b0bc >>>> IRQ=22 >>>> IDENT=hcfpcimodem >>>> >>>> For candidate modem in: 01:0e.0 >>>> 0700 Serial controller: Rockwell International HCF 56k Data/Fax Modem >>>> Primary device ID: 127a:1003 >>>> Support type needed or chipset: hcfpcimodem >>>> >>>> >>>> >>>> For owners of a Dell PCs with Conexant HSF modems, a driver source >>>> package with full speed enabled is available, but requires driver >>>> compiling. Read DOCs/Conexant.txt >>>> >>>> The modem requires a hcflinmodem package. >>>> From http://www.linuxant.com/drivers/hcf/full/downloads-ubuntu-x86.php >>>> download >>>> hcfpcimodem-7.80.02.02full_k2.6.28_11_generic_ubuntu_i386.deb.zip >>>> Under Linux unpack with: >>>> $ unzip hcfpcimodem*.zip >>>> Then install with: >>>> $ sudo dpkg -i hcfpcimodem*.deb >>>> Subsequently, the modem should be found with >>>> $ sudo wvdialconf /etc/wvdial.conf >>>> Edit in your personal information with: >>>> $ sudo gedit /etc/wvdial.conf >>>> and try dialing out with: >>>> $ sudo wvdial. >>>> See DOCs/Testing.txt for details. >>>> >>>> Read DOCs/Conexant.txt >>>> >>>> Regards, >>>> >>>> Antonio >>>> >>>> On 7/30/09, jimn1547@xxxxxxxxxxxx <jimn1547@xxxxxxxxxxxx> wrote: >>>>> >>> >>> > >
