hi
i get new modem and
attached
ModemData.txt
if
my modem is hcf i can
use hsf dell driver because i have any money to sale
linuxant driver if ok what whould i doing?
thanks
Get your new Email address!
Grab the Email name you've always wanted before someone else does!
http://mail.promotions.yahoo.com/newdomains/aa/ Only plain text email is forwarded by the Discuss@xxxxxxxxxxxxx List Server,
as HTML can contain viruses. Use as the email Subject Line:
YourName, YourCountry kernel 2.6.25-14.fc9.i686
With this Subject Line cogent experts will be alerted, and useful case names left in the Archive.
YourCountry will enable Country specific guidance. Linux experts in YourCountry
can be found through: http://www.linux.org/groups/index.html.
They will know your Country's modem code, which may be essential for dialup service.
Responses from Discuss@xxxxxxxxxxxxx are sometimes blocked by an Internet Provider mail filters.
So in a day, also check the Archived responses at http://www.linmodems.org
-------------------------- System information ----------------------------
CPU=i686,
Linux version 2.6.25-14.fc9.i686 (mockbuild@) (gcc version 4.3.0 20080428 (Red Hat 4.3.0-8) (GCC) ) #1 SMP Thu May 1 06:28:41 EDT 2008
scanModem update of: 2008_08_26
There are no blacklisted modem drivers in /etc/modprobe* files
Attached USB devices are:
ID 0951:1607 Kingston Technology
ID 1d6b:0002 Linux Foundation 2.0 root hub
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 04b4:0033 Cypress Semiconductor Corp.
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 1d6b:0001 Linux Foundation 1.1 root hub
USB modems not recognized
For candidate card in slot 04:01.0, firmware information and bootup diagnostics are:
PCI slot PCI ID SubsystemID Name
---------- --------- --------- --------------
04:01.0 14f1:1056 14f1:1056 Communication controller: Conexant HCF 56k Data/Fax/Voice/Spkp Modem
Modem interrupt assignment and sharing:
--- Bootup diagnostics for card in PCI slot 04:01.0 ----
For candidate card in slot 00:1b.0, firmware information and bootup diagnostics are:
PCI slot PCI ID SubsystemID Name
---------- --------- --------- --------------
00:1b.0 8086:27d8 1458:a102 Audio device: Intel Corporation 82801G
Modem interrupt assignment and sharing:
16: 4063 0 IO-APIC-fasteoi uhci_hcd:usb5, HDA Intel
--- Bootup diagnostics for card in PCI slot 00:1b.0 ----
ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 16 (level, low) -> IRQ 16
PCI: Setting latency timer of device 0000:00:1b.0 to 64
===== Advanced Linux Sound Architecture (ALSA) diagnostics =====
The ALSA packages provide audio support and also drivers for some modems.
ALSA diagnostics are written during bootup to /proc/asound/ folders.
The ALSA verion is 1.0.16
The modem cards detected by "aplay -l" are: None
The /proc/asound/pcm file reports:
-----------------------
00-02: ALC880 Analog : ALC880 Analog : capture 2
00-01: ALC880 Digital : ALC880 Digital : playback 1
00-00: ALC880 Analog : ALC880 Analog : playback 1 : capture 1
about /proc/asound/cards:
------------------------
0 [Intel ]: HDA-Intel - HDA Intel
HDA Intel at 0xe5100000 irq 16
PCI slot 00:1b.0 has a High Definition Audio Card
The drivers are in the kernel modules tree at:
/lib/modules/2.6.25-14.fc9.i686/kernel/sound/pci/hda/snd-hda-intel.ko
=== Finished firmware and bootup diagnostics, next deducing cogent software. ===
Predictive diagnostics for card in bus 04:01.0:
Modem chipset detected on
NAME="Communication controller: Conexant HCF 56k Data/Fax/Voice/Spkp Modem "
CLASS=0780
PCIDEV=14f1:1056
SUBSYS=14f1:1056
IRQ=11
IDENT=hcfpcimodem
For candidate modem in: 04:01.0
0780 Communication controller: Conexant HCF 56k Data/Fax/Voice/Spkp Modem
Primary device ID: 14f1:1056
Support type needed or chipset: hcfpcimodem
----------------end Softmodem section --------------
Writing DOCs/Intel.txt
For owners of a Dell PCs with Conexant HSF modems, a driver source package with full speed enabled is available, but requires driver compiling. Read DOCs/Conexant.txt
The modem requires a hcflinmodem package.
Start at http://www.linuxant.com/drivers/hcf/full for
eventually download of a hcfpcimodem-7.68.00.12full_k.???.zip package
with ??? the package type (deb, rpm, tar etc)
These packages have compiled drivers but will also compile a driver,
if there is a mismatch between the resident kernel and provided driver.
The generic hcfpcimodem-7.68.00.12full.tar.gz package only provides compiling support
Read DOCs/Conexant.txt
Writing DOCs/Conexant.txt
Predictive diagnostics for card in bus 00:1b.0:
Modem chipset not detected on
NAME="Audio device: Intel Corporation 82801G "
CLASS=0403
PCIDEV=8086:27d8
SUBSYS=1458:a102
IRQ=16
HDA=8086:27d8
SOFT=8086:27d8.HDA
High Definition Audio (HDA) cards MAY host a modem chip in their Subsystem,
and many are supported by the ALSA audio+modem driver snd-hda-intel
A modem was not detected on HDA card 8086:27d8.
If another modem card is present, then most likely 8086:27d8 does not host a modem.
If another modem card has not been detected, then possibilities are:
1) A Conexant modem chip is present on 8086:27d8, as Conexant chips
are frequently not detectable by ALSA diagnostics
2) The modem may be of the older non-PCI Controller Chipset (hardware) type.
Try detection with Root permission:
wvdialconf /etc/wvdial.conf
For candidate modem in: 00:1b.0
0403 Audio device: Intel Corporation 82801G
Primary device ID: 8086:27d8
Subsystem PCI_id 1458:a102
Softmodem codec or chipset from diagnostics:
from Archives:
Support type needed or chipset:
Support can likely be achieved through two mutually exclusive alternatives:
1) The hsfmodem software for Conexant chipset modems: Read DOCs/Conexant.txt
The following ALSA alternative CANNOT work with Conexant modems.
2) An ALSA modem driver plus slmodemd. Read DOCs/Smartlink.txt for details, and
to test get the package SLMODEMD.gcc4.3.tar.gz from:
http://linmodems.technion.ac.il/packages/smartlink/
----------------end Softmodem section --------------
Writing DOCs/Smartlink.txt
============ end Smartlink section =====================
Completed candidate modem analyses.
The base of the UDEV device file system is: /dev/.udev
Versions adequately match for the compiler installed: 4.3.0
and the compiler used in kernel assembly: 4.3.0
linux-headers-2.6.25-14.fc9.i686 resources needed for compiling are not manifestly ready!
If compiling is necessary packages must be installed, providing:
If a driver compilation fails, with message including some lack of some FileName.h (stdio.h for example), then
Some additional kernel-header files need installation to /usr/include. The minimal additional packages are libc6-dev
and any of its dependents, under Ubuntu linux-libc-dev
If an alternate ethernet connection is available,
$ apt-get update
$ apt-get -s install linux-kernel-devel
will install needed packages.
For Debian/Ubuntu related distributions, run the following command to display the needed package list:
Otherwise packages have to be found through http://packages.ubuntu.com
Once downloaded and transferred into a Linux partition,
they can be installed alltogether with:
$ sudo dpkg -i *.deb
Checking pppd properties:
-r-xr-xr-x 1 root root 317736 2008-03-12 12:44 /usr/sbin/pppd
In case of an "error 17" "serial loopback" problem, see:
http://linmodems.technion.ac.il/linmodems/archive-sixth/msg02637.html
To enable dialout without Root permission do:
$ su - root (not for Ubuntu)
chmod a+x /usr/sbin/pppd
or under Ubuntu related Linuxes
chmod a+x /usr/sbin/pppd
Checking settings of: /etc/ppp/options
lock
In case of a message like:
Warning: Could not modify /etc/ppp/pap-secrets: Permission denied
see http://linmodems.technion.ac.il/bigarch/archive-sixth/msg04656.html
Read Modem/DOCs/YourSystem.txt concerning other COMM channels: eth0 virbr0
Which can interfere with Browser naviagation.
Don't worry about the following, it is for experts should trouble shooting be necessary.
==========================================================
Checking for modem support lines:
--------------------------------------
/device/modem symbolic link:
slmodemd created symbolic link /dev/ttySL0:
Within /etc/udev/ files:
/etc/udev/rules.d/50-udev-default.rules:KERNEL=="mwave", NAME="modems/mwave", GROUP="uucp"
Within /etc/modprobe.conf files:
Within any ancient /etc/devfs files:
Within ancient kernel 2.4.n /etc/module.conf files:
--------- end modem support lines --------
