Hi, I have attached my modem data. Looking forward to get help. I have
looked at the modem data and I am proceeding to download the version
of slmodemd* which the scanmodem has suggested. I tried to compile
from the earlier version of slmodemd that I used in opensuse 10.3 but
it showed errors. I hope it works.
Only plain text email is forwarded by the Discuss@xxxxxxxxxxxxx List Server,
as HTML can contain viruses. Use as the email Subject Line:
YourName, YourCountry
Welcome to openSUSE 11.0 (i586) - Kernel kernel 2.6.25.5-1.1-pae
With this Subject Line cogent experts will be alerted, and useful case names left in the Archive.
YourCountry will enable Country specific guidance. Linux experts in YourCountry
can be found through: http://www.linux.org/groups/index.html.
They will know your Country's modem code, which may be essential for dialup service.
Responses from Discuss@xxxxxxxxxxxxx are sometimes blocked by an Internet Provider mail filters.
So in a day, also check the Archived responses at http://www.linmodems.org
-------------------------- System information ----------------------------
CPU=i686,
Welcome to openSUSE 11.0 (i586) - Kernel
Linux version 2.6.25.5-1.1-pae (geeko@buildhost) (gcc version 4.3.1 20080507 (prerelease) [gcc-4_3-branch revision 135036] (SUSE Linux) ) #1 SMP 2008-06-07 01:55:22 +0200
scanModem update of: 2008_08_15
There are no blacklisted modem drivers in /etc/modprobe* files
Attached USB devices are:
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 1d6b:0001 Linux Foundation 1.1 root hub
ID 13fe:1d00 Kingston Technology Company Inc. DataTraveler 2.0 1GB/4GB Flash Drive / Patriot Xporter 4GB Flash Drive
ID 1d6b:0002 Linux Foundation 2.0 root hub
USB modems not recognized
For candidate card in slot 05:03.0, firmware information and bootup diagnostics are:
PCI slot PCI ID SubsystemID Name
---------- --------- --------- --------------
05:03.0 1057:3052 1057:3020 Modem: Motorola SM56 Data Fax Modem
Modem interrupt assignment and sharing:
--- Bootup diagnostics for card in PCI slot 05:03.0 ----
ACPI: PCI Interrupt 0000:05:03.0[A] -> GSI 16 (level, low) -> IRQ 16
0000:05:03.0: ttyS1 at I/O 0xc808 (irq = 16) is a 16450
0000:05:03.0: ttyS2 at I/O 0xc810 (irq = 16) is a 8250
0000:05:03.0: ttyS3 at I/O 0xc818 (irq = 16) is a 16450
Couldn't register serial port 0000:05:03.0: -28
For candidate card in slot 04:01.0, firmware information and bootup diagnostics are:
PCI slot PCI ID SubsystemID Name
---------- --------- --------- --------------
04:01.0 1106:3288 1019:2171 Audio device: VIA Technologies, Inc. VIA High Definition Audio Controller
Modem interrupt assignment and sharing:
17: 704 IO-APIC-fasteoi HDA Intel
--- Bootup diagnostics for card in PCI slot 04:01.0 ----
ACPI: PCI Interrupt 0000:04:01.0[A] -> GSI 17 (level, low) -> IRQ 17
PCI: Setting latency timer of device 0000:04:01.0 to 64
=== Finished firmware and bootup diagnostics, next deducing cogent software. ===
Predictive diagnostics for card in bus 05:03.0:
Modem chipset detected on
NAME="Modem: Motorola SM56 Data Fax Modem "
CLASS=0703
PCIDEV=1057:3052
SUBSYS=1057:3020
IRQ=16
IDENT=slamr
For candidate modem in: 05:03.0
0703 Modem: Motorola SM56 Data Fax Modem
Primary device ID: 1057:3052
Support type needed or chipset: slamr
----------------end Softmodem section --------------
1057:3052 has a Motorola chipset, poorly supported by Motorola itself
However Zello discovered that drivers written to support Smartlink modems do support the 1057:3052 chipset!!
It sufficed to add 1057:3052 to the list of modem cards recognized by the Smartlink slamr driver.
There is a ungrab-winmodem driver used in conjunction with slamr, which must have 1057:3052
similarly added. See messages from Zello:
http://linmodems.technion.ac.il/bigarch/archive-seventh/msg00846.html
http://linmodems.technion.ac.il/bigarch/archive-seventh/msg00848.html
and Alvaro Aguirre about the ungrab-winmodem fix:
http://linmodems.technion.ac.il/bigarch/archive-seventh/msg00990.html
For general guidance on ungrab-winmodem + slamr usage, read the DOCs/Smartlink.txt
The modem is supported by the Smartlink
plus the slmodemd helper utility. Read the
DOCs/Smartlink.txt and Modem/DOCs/YourSystem.txt for follow through guidance.
For 2.6.25.5-1.1-pae compiling drivers is necessary. As of October 2007 the current packages at
http://linmodems.technion.ac.il/packages/smartlink/ are the
ungrab-winmodem-20070505.tar.gz and slmodem-2.9.11-20080126.tar.gz
Writing DOCs/Smartlink.txt
============ end Smartlink section =====================
Predictive diagnostics for card in bus 04:01.0:
Modem chipset not detected on
NAME="Audio device: VIA Technologies, Inc. VIA High Definition Audio Controller "
CLASS=0403
PCIDEV=1106:3288
SUBSYS=1019:2171
IRQ=17
HDA=1106:3288
SOFT=1106:3288.HDA
High Definition Audio (HDA) cards MAY host a modem chip in their Subsystem,
and many are supported by the ALSA audio+modem driver snd-hda-intel
A modem was not detected on HDA card 1106:3288.
If another modem card is present, then most likely 1106:3288 does not host a modem.
If another modem card has not been detected, then possibilities are:
1) A Conexant modem chip is present on 1106:3288, as Conexant chips
are frequently not detectable by ALSA diagnostics
2) The modem may be of the older non-PCI Controller Chipset (hardware) type.
Try detection with Root permission:
wvdialconf /etc/wvdial.conf
For candidate modem in: 04:01.0
0403 Audio device: VIA Technologies, Inc. VIA High Definition Audio Controller
Primary device ID: 1106:3288
Subsystem PCI_id 1019:2171
Softmodem codec or chipset from diagnostics:
from Archives:
Support type needed or chipset:
Support can likely be achieved through two mutually exclusive alternatives:
1) The hsfmodem software for Conexant chipset modems: Read DOCs/Conexant.txt
The following ALSA alternative CANNOT work with Conexant modems.
2) An ALSA modem driver plus slmodemd. Read DOCs/Smartlink.txt for details, and
to test get the package SLMODEMD.gcc4.3.tar.gz from:
http://linmodems.technion.ac.il/packages/smartlink/
----------------end Softmodem section --------------
Completed candidate modem analyses.
The base of the UDEV device file system is: /dev/.udev
Versions adequately match for the compiler installed: 4.3.1
and the compiler used in kernel assembly: 4.3
Minimal compiling resources appear complete:
make utility - /usr/bin/make
Compiler version 4.3
linuc_headers base folder /lib/modules/2.6.25.5-1.1-pae/build
However some compilations and executable functions may need additional files,
in the FileNames.h (so called kernel "h"eaders) collection installed in /usr/include/ .
For martian_modem, additional required packages are n. The also required headers of package libc6 are commonly installed by default.
Compiling hsfmodem drivers does require linux-libc-dev and libc6-dev packages, for kernels 2.6.24 and later versions.
In not included on your install CD, search for them at http://packages.ubuntu.com
or comparable Repository for other Linux distros.
When compiling ALSA drivers, the utility "patch" will also be needed.
If a driver compilation fails, with message including some lack of some FileName.h (stdio.h for example), then
Some additional kernel-header files need installation to /usr/include. The minimal additional packages are libc6-dev
and any of its dependents, under Ubuntu linux-libc-dev
If an alternate ethernet connection is available,
$ apt-get update
$ apt-get -s install linux-kernel-devel
will install needed packages.
For Debian/Ubuntu related distributions, run the following command to display the needed package list:
Otherwise packages have to be found through http://packages.ubuntu.com
Once downloaded and transferred into a Linux partition,
they can be installed alltogether with:
$ sudo dpkg -i *.deb
Checking pppd properties:
-rwxr-xr-x 1 root dialout 304644 2008-06-07 03:06 /usr/sbin/pppd
In case of an "error 17" "serial loopback" problem, see:
http://linmodems.technion.ac.il/linmodems/archive-sixth/msg02637.html
To enable dialout without Root permission do:
$ su - root (not for Ubuntu)
chmod a+x /usr/sbin/pppd
or under Ubuntu related Linuxes
chmod a+x /usr/sbin/pppd
Checking settings of: /etc/ppp/options
noipdefault
noauth
crtscts
lock
modem
asyncmap 0
nodetach
lcp-echo-interval 30
lcp-echo-failure 4
lcp-max-configure 60
lcp-restart 2
idle 600
noipx
file /etc/ppp/filters
In case of a message like:
Warning: Could not modify /etc/ppp/pap-secrets: Permission denied
see http://linmodems.technion.ac.il/bigarch/archive-sixth/msg04656.html
Don't worry about the following, it is for experts should trouble shooting be necessary.
==========================================================
Checking for modem support lines:
--------------------------------------
/device/modem symbolic link:
slmodemd created symbolic link /dev/ttySL0:
Within /etc/udev/ files:
/etc/udev/rules.d/50-udev-default.rules:KERNEL=="mwave", NAME="modems/mwave", GROUP="uucp"
/etc/udev/rules.d/77-network.rules:SUBSYSTEM=="net", ENV{INTERFACE}=="ppp*|ippp*|isdn*|plip*|lo*|irda*|dummy*|ipsec*|tun*|tap*|bond*|vlan*|modem*|dsl*", GOTO="skip_ifup"
Within /etc/modprobe.conf files:
/etc/modprobe.conf:# Linux ACP modem (Mwave)
Within any ancient /etc/devfs files:
Within ancient kernel 2.4.n /etc/module.conf files:
--------- end modem support lines --------
