From: Ville Syrjälä <ville.syrjala@xxxxxxxxxxxxxxx>
Rather than looking at crtc->mode (which is the user mode) dig up the
sync polarity settings from the adjusted_mode when programming
TRANS_DP_CTL on CPT/PPT.
Signed-off-by: Ville Syrjälä <ville.syrjala@xxxxxxxxxxxxxxx>
---
drivers/gpu/drm/i915/intel_display.c | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)
diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index d3cd177..99fb33f 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -4170,6 +4170,8 @@ static void ironlake_pch_enable(struct drm_crtc *crtc)
/* For PCH DP, enable TRANS_DP_CTL */
if (HAS_PCH_CPT(dev) && intel_crtc->config->has_dp_encoder) {
+ const struct drm_display_mode *adjusted_mode =
+ &intel_crtc->config->base.adjusted_mode;
u32 bpc = (I915_READ(PIPECONF(pipe)) & PIPECONF_BPC_MASK) >> 5;
reg = TRANS_DP_CTL(pipe);
temp = I915_READ(reg);
@@ -4179,9 +4181,9 @@ static void ironlake_pch_enable(struct drm_crtc *crtc)
temp |= TRANS_DP_OUTPUT_ENABLE;
temp |= bpc << 9; /* same format but at 11:9 */
- if (crtc->mode.flags & DRM_MODE_FLAG_PHSYNC)
+ if (adjusted_mode->flags & DRM_MODE_FLAG_PHSYNC)
temp |= TRANS_DP_HSYNC_ACTIVE_HIGH;
- if (crtc->mode.flags & DRM_MODE_FLAG_PVSYNC)
+ if (adjusted_mode->flags & DRM_MODE_FLAG_PVSYNC)
temp |= TRANS_DP_VSYNC_ACTIVE_HIGH;
switch (intel_trans_dp_port_sel(crtc)) {
--
2.4.10
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
http://lists.freedesktop.org/mailman/listinfo/intel-gfx
