From: Ville Syrjälä <ville.syrjala@xxxxxxxxxxxxxxx> When disabling interrupts we do the writes in this order: IMR,IER,IIR,IIR. But when enabling interrupts we don't do use the mirrored order, and instead do IIR,IIR,IMR,IER. I like consistency unless there's a good reason against it, which I can't think of here, so change the enable order to IIR,IIR,IER,IMR. Signed-off-by: Ville Syrjälä <ville.syrjala@xxxxxxxxxxxxxxx> --- drivers/gpu/drm/i915/i915_irq.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/drivers/gpu/drm/i915/i915_irq.c b/drivers/gpu/drm/i915/i915_irq.c index a2b013d..98a8d65 100644 --- a/drivers/gpu/drm/i915/i915_irq.c +++ b/drivers/gpu/drm/i915/i915_irq.c @@ -126,16 +126,16 @@ static const u32 hpd_status_i915[] = { /* i915 and valleyview are the same */ #define GEN8_IRQ_INIT_NDX(type, which, imr_val, ier_val) do { \ GEN5_ASSERT_IIR_IS_ZERO(GEN8_##type##_IIR(which)); \ - I915_WRITE(GEN8_##type##_IMR(which), (imr_val)); \ I915_WRITE(GEN8_##type##_IER(which), (ier_val)); \ - POSTING_READ(GEN8_##type##_IER(which)); \ + I915_WRITE(GEN8_##type##_IMR(which), (imr_val)); \ + POSTING_READ(GEN8_##type##_IMR(which)); \ } while (0) #define GEN5_IRQ_INIT(type, imr_val, ier_val) do { \ GEN5_ASSERT_IIR_IS_ZERO(type##IIR); \ - I915_WRITE(type##IMR, (imr_val)); \ I915_WRITE(type##IER, (ier_val)); \ - POSTING_READ(type##IER); \ + I915_WRITE(type##IMR, (imr_val)); \ + POSTING_READ(type##IMR); \ } while (0) /* For display hotplug interrupt */ -- 2.0.4 _______________________________________________ Intel-gfx mailing list Intel-gfx@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/intel-gfx