Re: [PATCH v5 17/28] drm/i915/dsc: Compute Rate Control parameters for DSC

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



________________________________________
From: Intel-gfx [intel-gfx-bounces@xxxxxxxxxxxxxxxxxxxxx] on behalf of Manasi Navare [manasi.d.navare@xxxxxxxxx]
Sent: Friday, October 05, 2018 4:22 PM
To: intel-gfx@xxxxxxxxxxxxxxxxxxxxx; dri-devel@xxxxxxxxxxxxxxxxxxxxx
Subject:  [PATCH v5 17/28] drm/i915/dsc: Compute Rate Control parameters for DSC

From: Gaurav K Singh <gaurav.k.singh@xxxxxxxxx>

This computation of RC params happens in the atomic commit phase
during compute_config() to validate if display stream compression
can be enabled for the requested mode.

v5 (From Manasi):
* Fix dim checkpatch warnings/checks
v4(From Gaurav):
* No change.Rebase on drm-tip

v3 (From Gaurav):
* Rebase on top of Manasi's latest series
* Return -ve value in case of failure scenarios (Manasi)

Fix review comments from Ville:
* Remove unnecessary comments
* Remove unnecessary paranthesis
* Add comments for few RC params calculations

v2 (From Manasi):
* Rebase Gaurav's patch from intel-gfx to gfx-internal
* Use struct drm_dsc_cfg instead of struct intel_dp
as a parameter

Cc: Manasi Navare <manasi.d.navare@xxxxxxxxx>
Cc: Jani Nikula <jani.nikula@xxxxxxxxxxxxxxx>
Cc: Ville Syrjala <ville.syrjala@xxxxxxxxxxxxxxx>
Signed-off-by: Gaurav K Singh <gaurav.k.singh@xxxxxxxxx>
Signed-off-by: Manasi Navare <manasi.d.navare@xxxxxxxxx>
---
 drivers/gpu/drm/i915/intel_vdsc.c | 127 ++++++++++++++++++++++++++++++
 1 file changed, 127 insertions(+)

diff --git a/drivers/gpu/drm/i915/intel_vdsc.c b/drivers/gpu/drm/i915/intel_vdsc.c
index 351ea7d71c21..594196a9d0f4 100644
--- a/drivers/gpu/drm/i915/intel_vdsc.c
+++ b/drivers/gpu/drm/i915/intel_vdsc.c
@@ -317,6 +317,130 @@ static int get_column_index_for_rc_params(u8 bits_per_component)
        }
 }

+static int intel_compute_rc_parameters(struct drm_dsc_config *vdsc_cfg)
+{
+       unsigned long groups_per_line = 0;
+       unsigned long groups_total = 0;
+       unsigned long num_extra_mux_bits = 0;
+       unsigned long slice_bits = 0;
+       unsigned long hrd_delay = 0;
+       unsigned long final_scale = 0;
+       unsigned long rbs_min = 0;
+
+       /* Number of groups used to code each line of a slice */
+       groups_per_line = DIV_ROUND_UP(vdsc_cfg->slice_width,
+                                      DSC_RC_PIXELS_PER_GROUP);
+
+       /* chunksize in Bytes */
+       vdsc_cfg->slice_chunk_size = DIV_ROUND_UP(vdsc_cfg->slice_width *
+                                                 vdsc_cfg->bits_per_pixel,
+                                                 (8 * 16));
+
+       if (vdsc_cfg->convert_rgb)
+               num_extra_mux_bits = 3 * (vdsc_cfg->mux_word_size +
+                                         (4 * vdsc_cfg->bits_per_component + 4)
+                                         - 2);
+       else
+               num_extra_mux_bits = 3 * vdsc_cfg->mux_word_size +
+                       (4 * vdsc_cfg->bits_per_component + 4) +
+                       2 * (4 * vdsc_cfg->bits_per_component) - 2;
+       /* Number of bits in one Slice */
+       slice_bits = 8 * vdsc_cfg->slice_chunk_size * vdsc_cfg->slice_height;
+
+       while ((num_extra_mux_bits > 0) &&
+              ((slice_bits - num_extra_mux_bits) % vdsc_cfg->mux_word_size))
+               num_extra_mux_bits--;
+
+       if (groups_per_line < vdsc_cfg->initial_scale_value - 8)
+               vdsc_cfg->initial_scale_value = groups_per_line + 8;
+
+       /* scale_decrement_interval calculation according to DSC spec 1.11 */
+       if (vdsc_cfg->initial_scale_value > 8)
+               vdsc_cfg->scale_decrement_interval = groups_per_line /
+                       (vdsc_cfg->initial_scale_value - 8);
+       else
+               vdsc_cfg->scale_decrement_interval = DSC_SCALE_DECREMENT_INTERVAL_MAX;
+
+       vdsc_cfg->final_offset = vdsc_cfg->rc_model_size -
+               (vdsc_cfg->initial_xmit_delay *
+                vdsc_cfg->bits_per_pixel + 8) / 16 + num_extra_mux_bits;
+
+       if (vdsc_cfg->final_offset >= vdsc_cfg->rc_model_size) {
+               DRM_ERROR("FinalOfs < RcModelSze for this InitialXmitDelay\n");
+               return -EINVAL;
+       }
+
+       final_scale = (vdsc_cfg->rc_model_size * 8) /
+               (vdsc_cfg->rc_model_size - vdsc_cfg->final_offset);
+       if (vdsc_cfg->slice_height > 1)
+               /*
+                * NflBpgOffset is 16 bit value with 11 fractional bits
+                * hence we multiply by 2^11 for preserving the
+                * fractional part
+                */
+               vdsc_cfg->nfl_bpg_offset = DIV_ROUND_UP((vdsc_cfg->first_line_bpg_offset << 11),
+                                                       (vdsc_cfg->slice_height - 1));
+       else
+               vdsc_cfg->nfl_bpg_offset = 0;
+
+       /* 2^16 - 1 */
+       if (vdsc_cfg->nfl_bpg_offset > 65535) {
+               DRM_ERROR("NflBpgOffset is too large for this slice height\n");
+               return -EINVAL;
+       }
+
+       /* Number of groups used to code the entire slice */
+       groups_total = groups_per_line * vdsc_cfg->slice_height;
+
+       /* slice_bpg_offset is 16 bit value with 11 fractional bits */
+       vdsc_cfg->slice_bpg_offset = DIV_ROUND_UP(((vdsc_cfg->rc_model_size -
+                                                   vdsc_cfg->initial_offset +
+                                                   num_extra_mux_bits) << 11),
+                                                 groups_total);
+
+       if (final_scale > 0x9) {
Why not just final_scale > 9?

Anusha 
+               /*
+                * ScaleIncrementInterval =
+                * finaloffset/((NflBpgOffset + SliceBpgOffset)*8(finalscale - 1.125))
+                * as (NflBpgOffset + SliceBpgOffset) has 11 bit fractional value,
+                * we need divide by 2^11 from pstDscCfg values
+                */
+               vdsc_cfg->scale_increment_interval =
+                               (vdsc_cfg->final_offset * (1 << 11)) /
+                               ((vdsc_cfg->nfl_bpg_offset +
+                               vdsc_cfg->slice_bpg_offset)*
+                               (final_scale - 9));
+       } else {
+               /*
+                * If finalScaleValue is less than or equal to 9, a value of 0 should
+                * be used to disable the scale increment at the end of the slice
+                */
+               vdsc_cfg->scale_increment_interval = 0;
+       }
+
+       if (vdsc_cfg->scale_increment_interval > 65535) {
+               DRM_ERROR("ScaleIncrementInterval is large for slice height\n");
+               return -EINVAL;
+       }
+
+       /*
+        * DSC spec mentions that bits_per_pixel specifies the target
+        * bits/pixel (bpp) rate that is used by the encoder,
+        * in steps of 1/16 of a bit per pixel
+        */
+       rbs_min = vdsc_cfg->rc_model_size - vdsc_cfg->initial_offset +
+               DIV_ROUND_UP(vdsc_cfg->initial_xmit_delay *
+                            vdsc_cfg->bits_per_pixel, 16) +
+               groups_per_line * vdsc_cfg->first_line_bpg_offset;
+
+       hrd_delay = DIV_ROUND_UP((rbs_min * 16), vdsc_cfg->bits_per_pixel);
+       vdsc_cfg->rc_bits = (hrd_delay * vdsc_cfg->bits_per_pixel) / 16;
+       vdsc_cfg->initial_dec_delay = hrd_delay - vdsc_cfg->initial_xmit_delay;
+
+       return 0;
+}
+
+
 int intel_dp_compute_dsc_params(struct intel_dp *intel_dp,
                                struct intel_crtc_state *pipe_config)
 {
@@ -451,5 +575,8 @@ int intel_dp_compute_dsc_params(struct intel_dp *intel_dp,
        vdsc_cfg->initial_scale_value = (vdsc_cfg->rc_model_size << 3) /
                (vdsc_cfg->rc_model_size - vdsc_cfg->initial_offset);

+       if (intel_compute_rc_parameters(vdsc_cfg) < 0)
+               return -1;
+
        return 0;
 }
--
2.18.0

_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/intel-gfx




[Index of Archives]     [AMD Graphics]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux