On 10/15/2018 7:57 PM, Jani Nikula wrote:
From: Madhav Chauhan <madhav.chauhan@xxxxxxxxx>
This patch programs D-PHY timing parameters for the
bus turn around flow(in escape clocks) only if dsi link
frequency <=800 MHz using DPHY_TA_TIMING_PARAM and its
identical register DSI_TA_TIMING_PARAM (inside DSI
Controller within the Display Core).
v2: Changes
- Don't use KHz() macro (Ville/Jani N)
- Use newly defined bitfields
v3 by Jani:
- Use intel_dsi_bitrate() in favor of a new field
- Remove redundant parens
v3 changes looks fine to me.
Regards,
Madhav
Signed-off-by: Madhav Chauhan <madhav.chauhan@xxxxxxxxx>
Signed-off-by: Jani Nikula <jani.nikula@xxxxxxxxx>
---
drivers/gpu/drm/i915/icl_dsi.c | 21 +++++++++++++++++++++
1 file changed, 21 insertions(+)
diff --git a/drivers/gpu/drm/i915/icl_dsi.c b/drivers/gpu/drm/i915/icl_dsi.c
index 9602b6532028..f9df3a7fa66b 100644
--- a/drivers/gpu/drm/i915/icl_dsi.c
+++ b/drivers/gpu/drm/i915/icl_dsi.c
@@ -309,6 +309,27 @@ static void gen11_dsi_setup_dphy_timings(struct intel_encoder *encoder)
I915_WRITE(DSI_DATA_TIMING_PARAM(port),
intel_dsi->dphy_data_lane_reg);
}
+
+ /*
+ * If DSI link operating at or below an 800 MHz,
+ * TA_SURE should be override and programmed to
+ * a value '0' inside TA_PARAM_REGISTERS otherwise
+ * leave all fields at HW default values.
+ */
+ if (intel_dsi_bitrate(intel_dsi) <= 800000) {
+ for_each_dsi_port(port, intel_dsi->ports) {
+ tmp = I915_READ(DPHY_TA_TIMING_PARAM(port));
+ tmp &= ~TA_SURE_MASK;
+ tmp |= TA_SURE_OVERRIDE | TA_SURE(0);
+ I915_WRITE(DPHY_TA_TIMING_PARAM(port), tmp);
+
+ /* shadow register inside display core */
+ tmp = I915_READ(DSI_TA_TIMING_PARAM(port));
+ tmp &= ~TA_SURE_MASK;
+ tmp |= TA_SURE_OVERRIDE | TA_SURE(0);
+ I915_WRITE(DSI_TA_TIMING_PARAM(port), tmp);
+ }
+ }
}
static void gen11_dsi_enable_port_and_phy(struct intel_encoder *encoder)
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
