On Thu, Jun 01, 2017 at 03:55:13PM +0300, Jani Nikula wrote: > On Wed, 31 May 2017, Ville Syrjälä <ville.syrjala@xxxxxxxxxxxxxxx> wrote: > > On Wed, May 31, 2017 at 08:05:35PM +0300, Imre Deak wrote: > >> Atm disabling either DP or eDP outputs can generate a spurious short > >> pulse interrupt. The reason is that after disabling the port the source > >> will stop sending a valid stream data, while the sink expects either a > >> valid stream or the idle pattern. Since neither of this is sent the sink > >> assumes (after an arbitrary delay) that the link is lost and requests > >> for link retraining with a short pulse. > >> > >> The spurious pulse is a real problem at least for eDP panels with long > >> power-off / power-cycle delays: as part of disabling the output we > >> disable the panel power. The subsequent spurious short pulse handling > >> will have to turn the power back on, which means the driver has to do a > >> redundant wait for the power-off and power-cycle delays. During system > >> suspend this leads to an unnecessary delay up to ~1s on systems with > >> such panels as reported by Rui. > >> > >> To fix this put the sink to DPMS D3 state before turning off the port. > >> According to the DP spec in this state the sink should not request > >> retraining. This is also what we do already on pre-ddi platforms. > >> > >> As an alternative I also tried configuring the port to send idle pattern > >> - which is against BSPec - and leave the port in normal mode before > >> turning off the port. Neither of these resolved the problem. > >> > >> Cc: Zhang Rui <rui.zhang@xxxxxxxxx> > >> Cc: David Weinehall <david.weinehall@xxxxxxxxxxxxxxx> > >> Cc: Ville Syrjälä <ville.syrjala@xxxxxxxxxxxxxxx> > >> Reported-and-tested-by: Zhang Rui <rui.zhang@xxxxxxxxx> > >> Signed-off-by: Imre Deak <imre.deak@xxxxxxxxx> > > > > Makes sense to me. > > I wonder if we should write D0 on hotplug. D0 is the default power state IIRC, so when you plug something in it should automagically go into D0. That's actually a slight problem power-wise if there's no subsequent modeset to drop it into D3. -- Ville Syrjälä Intel OTC _______________________________________________ Intel-gfx mailing list Intel-gfx@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/intel-gfx
