On Fri, Apr 08, 2016 at 02:11:36PM -0700, Ben Greear wrote: > So, I will try to code up a patch to set the VENDOR_ELEM values using > the .conf file if you will accept the patch. I might.. I've been trying to think what would be a nice way of doing this as a general solution, but could not really find one. In some sense, I'd like to support all VENDOR_ELEM values in a manner that would allow easy extension of this similarly to how the VENDOR_ELEM_* commands themselves do. However, the current configuration parsing logic does not really make that very convenient (e.g., having "vendor_elem_default_0" .. "vendor_elem_default_14" as separately defined parameters can be hundred or more lines of code..). Maybe it would easiest to just add the two configuration parameters that you had in the patch and update the documentation to state that they are initial values used at interface start and changes during operation need to be done using the VENDOR_ELEM* commands. This is neither generic nor very clean, but at least the amount of code to maintain for this would be pretty minimal. -- Jouni Malinen PGP id EFC895FA _______________________________________________ Hostap mailing list Hostap@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/hostap