On 02/09/2023 20:28, Ayush Singh wrote: > The BeaglePlay board by BeagleBoard.org has a CC1352 co-processor. This > co-processor is connected to the main AM62 (running Linux) over UART. The > CC1352 can run Zephyr and other embedded OS. This commit adds support for > the CC1352 in the Linux kernel DTS. This allows Linux platform drivers to > identify the device and communicate with it. > > This UART is used by gb-beagleplay, an upcoming Greybus driver for > BeaglePlay. upcoming? So not present in this patchset? > > Signed-off-by: Ayush Singh <ayushdevel1325@xxxxxxxxx> > --- > arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts | 4 ++++ > 1 file changed, 4 insertions(+) > > diff --git a/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts b/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts > index 7cfdf562b53b..10abbb8feda5 100644 > --- a/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts > +++ b/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts > @@ -870,6 +870,10 @@ &main_uart6 { > pinctrl-names = "default"; > pinctrl-0 = <&wifi_debug_uart_pins_default>; > status = "okay"; > + > + beaglecc1352 { Node names should be generic. See also an explanation and list of examples (not exhaustive) in DT specification: https://devicetree-specification.readthedocs.io/en/latest/chapter2-devicetree-basics.html#generic-names-recommendation It does not look like you tested the DTS against bindings. Please run `make dtbs_check W=1` (see Documentation/devicetree/bindings/writing-schema.rst or https://www.linaro.org/blog/tips-and-tricks-for-validating-devicetree-sources-with-the-devicetree-schema/ for instructions). Best regards, Krzysztof _______________________________________________ greybus-dev mailing list -- greybus-dev@xxxxxxxxxxxxxxxx To unsubscribe send an email to greybus-dev-leave@xxxxxxxxxxxxxxxx