Re: Release 3.12: Glusto run status

[Shwetha Panduranga <spandura@xxxxxxxxxx>]

Case:

1) add-brick when IO is in progress , wait for 30 seconds

2) Trigger rebalance

3) Execute: 'rebalance status' ( there is no time delay b/w 2) and 3) )

4) wait_for_rebalance_to_complete ( This get's the xml output of rebalance status and keep checking for rebalance status to be 'complete' for every 10 seconds uptil 5 minutes. 5 minutes wait time can be passed as parameter )

At every step we check the exit status of the command output. If the exit status is non-zero we fail the test case.

-Shwetha

On Wed, Aug 30, 2017 at 6:06 AM, Sankarshan Mukhopadhyay <sankarshan.mukhopadhyay@xxxxxxxxx> wrote:

On Wed, Aug 30, 2017 at 6:03 AM, Atin Mukherjee <amukherj@xxxxxxxxxx> wrote:
>
> On Wed, 30 Aug 2017 at 00:23, Shwetha Panduranga <spandura@xxxxxxxxxx>
> wrote:
>>
>> Hi Shyam, we are already doing it. we wait for rebalance status to be
>> complete. We loop. we keep checking if the status is complete for '20'
>> minutes or so.
>
>
> Are you saying in this test rebalance status was executed multiple times
> till it succeed? If yes then the test shouldn't have failed. Can I get to
> access the complete set of logs?

Would you not prefer to look at the specific test under discussion as well?
_______________________________________________
Gluster-devel mailing list
Gluster-devel@xxxxxxxxxxx
http://lists.gluster.org/mailman/listinfo/gluster-devel

_______________________________________________
Gluster-devel mailing list
Gluster-devel@xxxxxxxxxxx
http://lists.gluster.org/mailman/listinfo/gluster-devel