I just upgraded from
FC2 to FC3test3 and noticed a new behavior with my Netgear
WG511.
In FC2 I would get a
failure during network init because eth1 (the prism54) was not found. As soon as
pcmcia started then the module would load and insert into my wireless network
without any action from me.
Now in FC3test3, the
prism54 module loads and complains about not being able to load the firmware
(the firmware is in the correct place according to /etc/hotplug/firmware.agent).
As soon as get a shell I rmmod prism54 and modprobe prism54 and it loads and is
able to upload the firmware just fine (which I have now added the rmmod and
modprobe to rc.local so I can reboot remotely and still gain access after
reboot). I updated all packages (including kernel) that were available from yum
and the same symptoms are there. I searched bugzilla and didn't see anything on
the prism54.
Has anyone seen
this, or should it go to bugzilla?
dmesg:
.......
device-mapper:
4.1.0-ioctl (2003-12-10) initialised: dm@xxxxxxxxxxxxxx
cdrom: open failed.
kjournald starting. Commit interval 5 seconds
EXT3 FS on hda1, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
Adding 524152k swap on /dev/hda3. Priority:-1 extents:1
IA-32 Microcode Update Driver: v1.14 <tigran@xxxxxxxxxxx>
microcode: No new microdata for cpu 0
ip_tables: (C) 2000-2002 Netfilter core team
ip_tables: (C) 2000-2002 Netfilter core team
eth1: islpci_open()
eth1: resetting device...
eth1: uploading firmware...
prism54: request_firmware() failed for 'isl3890'
eth1: could not upload firmware ('isl3890')
eth1: islpci_open()
eth1: resetting device...
eth1: uploading firmware...
prism54: request_firmware() failed for 'isl3890'
eth1: could not upload firmware ('isl3890')
eth1: islpci_open()
eth1: resetting device...
eth1: uploading firmware...
prism54: request_firmware() failed for 'isl3890'
eth1: could not upload firmware ('isl3890')
eth1: islpci_open()
eth1: resetting device...
eth1: uploading firmware...
prism54: request_firmware() failed for 'isl3890'
eth1: could not upload firmware ('isl3890')
eth1: islpci_open()
eth1: resetting device...
eth1: uploading firmware...
prism54: request_firmware() failed for 'isl3890'
eth1: could not upload firmware ('isl3890')
cs: IO port probe 0x0c00-0x0cff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x170-0x177 0x370-0x377 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
i2c /dev entries driver
lp: driver loaded but no devices found ---------------- End of boot
eth1: removing device ---------------------------- rmmod prism54
divert: freeing divert_blk for eth1
Unloaded prism54 driver
Loaded prism54 driver, version 1.2 ---------------------- modprobe prism54
ACPI: PCI interrupt 0000:06:00.0[A] -> GSI 11 (level, low) -> IRQ 11
divert: allocating divert_blk for eth1
ip_tables: (C) 2000-2002 Netfilter core team
eth1: islpci_open()
eth1: resetting device...
eth1: uploading firmware...
eth1: firmware uploaded done, now triggering reset...
ip_tables: (C) 2000-2002 Netfilter core team
cdrom: open failed.
kjournald starting. Commit interval 5 seconds
EXT3 FS on hda1, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
Adding 524152k swap on /dev/hda3. Priority:-1 extents:1
IA-32 Microcode Update Driver: v1.14 <tigran@xxxxxxxxxxx>
microcode: No new microdata for cpu 0
ip_tables: (C) 2000-2002 Netfilter core team
ip_tables: (C) 2000-2002 Netfilter core team
eth1: islpci_open()
eth1: resetting device...
eth1: uploading firmware...
prism54: request_firmware() failed for 'isl3890'
eth1: could not upload firmware ('isl3890')
eth1: islpci_open()
eth1: resetting device...
eth1: uploading firmware...
prism54: request_firmware() failed for 'isl3890'
eth1: could not upload firmware ('isl3890')
eth1: islpci_open()
eth1: resetting device...
eth1: uploading firmware...
prism54: request_firmware() failed for 'isl3890'
eth1: could not upload firmware ('isl3890')
eth1: islpci_open()
eth1: resetting device...
eth1: uploading firmware...
prism54: request_firmware() failed for 'isl3890'
eth1: could not upload firmware ('isl3890')
eth1: islpci_open()
eth1: resetting device...
eth1: uploading firmware...
prism54: request_firmware() failed for 'isl3890'
eth1: could not upload firmware ('isl3890')
cs: IO port probe 0x0c00-0x0cff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x170-0x177 0x370-0x377 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
i2c /dev entries driver
lp: driver loaded but no devices found ---------------- End of boot
eth1: removing device ---------------------------- rmmod prism54
divert: freeing divert_blk for eth1
Unloaded prism54 driver
Loaded prism54 driver, version 1.2 ---------------------- modprobe prism54
ACPI: PCI interrupt 0000:06:00.0[A] -> GSI 11 (level, low) -> IRQ 11
divert: allocating divert_blk for eth1
ip_tables: (C) 2000-2002 Netfilter core team
eth1: islpci_open()
eth1: resetting device...
eth1: uploading firmware...
eth1: firmware uploaded done, now triggering reset...
ip_tables: (C) 2000-2002 Netfilter core team
lspci:
00:00.0 Host bridge:
Intel Corp. 440BX/ZX/DX - 82443BX/ZX/DX Host bridge (rev 03)
00:01.0 PCI bridge: Intel Corp. 440BX/ZX/DX - 82443BX/ZX/DX AGP bridge (rev 03)
00:04.0 CardBus bridge: Texas Instruments PCI1450 (rev 03)
00:04.1 CardBus bridge: Texas Instruments PCI1450 (rev 03)
00:07.0 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ISA (rev 02)
00:07.1 IDE interface: Intel Corp. 82371AB/EB/MB PIIX4 IDE (rev 01)
00:07.2 USB Controller: Intel Corp. 82371AB/EB/MB PIIX4 USB (rev 01)
00:07.3 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ACPI (rev 03)
00:08.0 Multimedia audio controller: ESS Technology ES1978 Maestro 2E (rev 10)
00:09.0 Ethernet controller: Intel Corp. 82557/8/9 [Ethernet Pro 100] (rev 09)
00:09.1 Serial controller: Agere Systems (former Lucent Microelectronics) LT WinModem
01:00.0 VGA compatible controller: ATI Technologies Inc Rage Mobility P/M AGP 2x (rev 64)
06:00.0 Network controller: Intersil Corporation Intersil ISL3890 [Prism GT/Prism Duette] (rev 01)
00:01.0 PCI bridge: Intel Corp. 440BX/ZX/DX - 82443BX/ZX/DX AGP bridge (rev 03)
00:04.0 CardBus bridge: Texas Instruments PCI1450 (rev 03)
00:04.1 CardBus bridge: Texas Instruments PCI1450 (rev 03)
00:07.0 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ISA (rev 02)
00:07.1 IDE interface: Intel Corp. 82371AB/EB/MB PIIX4 IDE (rev 01)
00:07.2 USB Controller: Intel Corp. 82371AB/EB/MB PIIX4 USB (rev 01)
00:07.3 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ACPI (rev 03)
00:08.0 Multimedia audio controller: ESS Technology ES1978 Maestro 2E (rev 10)
00:09.0 Ethernet controller: Intel Corp. 82557/8/9 [Ethernet Pro 100] (rev 09)
00:09.1 Serial controller: Agere Systems (former Lucent Microelectronics) LT WinModem
01:00.0 VGA compatible controller: ATI Technologies Inc Rage Mobility P/M AGP 2x (rev 64)
06:00.0 Network controller: Intersil Corporation Intersil ISL3890 [Prism GT/Prism Duette] (rev 01)