Re: Prism54 firmware load failure only during boot

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, 2004-10-22 at 09:05, Neil Gierman wrote:

> Now in FC3test3, the prism54 module loads and complains about not
> being able to load the firmware (the firmware is in the correct place
> according to /etc/hotplug/firmware.agent). As soon as get a shell I
> rmmod prism54 and modprobe prism54 and it loads and is able to upload
> the firmware just fine (which I have now added the rmmod and modprobe
> to rc.local so I can reboot remotely and still gain access after
> reboot). I updated all packages (including kernel) that were available
> from yum and the same symptoms are there. I searched bugzilla and
> didn't see anything on the prism54.
>  
> Has anyone seen this, or should it go to bugzilla?
>  

I opened bug #129155 some time ago. It applies to FC2 and a minipci card
(prism54 chipset). Perhaps the same problem has been extended to FC3 and
cardbus.

-- 
Harold Campbell <hcamp@xxxxxxxxxx>


[Index of Archives]     [Fedora Desktop]     [Fedora SELinux]     [Photo Sharing]     [Yosemite Forum]     [KDE Users]