On Fri, 2004-10-22 at 09:05 -0500, Neil Gierman wrote: > Now in FC3test3, the prism54 module loads and complains about not > being able to load the firmware (the firmware is in the correct place > according to /etc/hotplug/firmware.agent). As soon as get a shell I > rmmod prism54 and modprobe prism54 and it loads and is able to upload > the firmware just fine (which I have now added the rmmod and modprobe > to rc.local so I can reboot remotely and still gain access after > reboot). I updated all packages (including kernel) that were available > from yum and the same symptoms are there. I searched bugzilla and > didn't see anything on the prism54. The real fix for this problem is to upgrade to a version of the udev RPM that's greater than or equal to 0.39-3. A specific fix was put in to deal with this problem in udev in that version. Dan