Reviewed-by: Alexandre Mergnat <amergnat@xxxxxxxxxxxx>
On 17/07/2023 16:14, AngeloGioacchino Del Regno wrote:
In order to support usecases in which the panel regulator can be
switched on and off to save power, and usecases in which the panel
regulator is off at boot, add a .wait_hpd_asserted() callback for
the AUX bus: this will make sure to wait until the panel is fully
ready after power-on before trying to communicate with it.
Also, parse the eDP display capabilities in that callback, so that
we can also avoid using the .get_edid() callback from this bridge.
Since at this point the hpd machinery is performed in the new hpd
callback and the detection and edid reading are done outside of
this driver, assign the DRM_BRIDGE_OP_{DETECT, EDID, HPD} ops and
register the bridge unconditionally at probe time only if we are
probing full DisplayPort and not eDP while, for the latter, we
register the bridge in the .done_probing() callback and only if
the panel was found and triggered HPD.
--
Regards,
Alexandre
