Hi Nikolaus, Thank you for the patch. On Wed, Apr 06, 2022 at 06:26:08PM +0200, H. Nikolaus Schaller wrote: > "hdmi-connector.yaml" bindings defines an optional property > "ddc-en-gpios" for a single gpio to enable DDC operation. > > Usually this controls +5V power on the HDMI connector. > This +5V may also be needed for HPD. > > This was not reflected in code but is needed to make the CI20 > board work. > > Now, the driver activates the ddc gpio after probe and > deactivates after remove so it is "almost on". > > But only if this driver is loaded (and not e.g. blacklisted > as module). > > Signed-off-by: H. Nikolaus Schaller <hns@xxxxxxxxxxxxx> Reviewed-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx> > --- > drivers/gpu/drm/bridge/display-connector.c | 15 +++++++++++++++ > 1 file changed, 15 insertions(+) > > diff --git a/drivers/gpu/drm/bridge/display-connector.c b/drivers/gpu/drm/bridge/display-connector.c > index d24f5b90feabf..e4d52a7e31b71 100644 > --- a/drivers/gpu/drm/bridge/display-connector.c > +++ b/drivers/gpu/drm/bridge/display-connector.c > @@ -24,6 +24,7 @@ struct display_connector { > int hpd_irq; > > struct regulator *dp_pwr; > + struct gpio_desc *ddc_en; > }; > > static inline struct display_connector * > @@ -345,6 +346,17 @@ static int display_connector_probe(struct platform_device *pdev) > } > } > > + /* enable DDC */ > + if (type == DRM_MODE_CONNECTOR_HDMIA) { > + conn->ddc_en = devm_gpiod_get_optional(&pdev->dev, "ddc-en", > + GPIOD_OUT_HIGH); > + > + if (IS_ERR(conn->ddc_en)) { > + dev_err(&pdev->dev, "Couldn't get ddc-en gpio\n"); > + return PTR_ERR(conn->ddc_en); > + } > + } > + > conn->bridge.funcs = &display_connector_bridge_funcs; > conn->bridge.of_node = pdev->dev.of_node; > > @@ -373,6 +385,9 @@ static int display_connector_remove(struct platform_device *pdev) > { > struct display_connector *conn = platform_get_drvdata(pdev); > > + if (conn->ddc_en) > + gpiod_set_value(conn->ddc_en, 0); > + > if (conn->dp_pwr) > regulator_disable(conn->dp_pwr); > -- Regards, Laurent Pinchart