Hi, Xinlei: On Fri, 2022-02-11 at 22:30 +0800, xinlei.lee@xxxxxxxxxxxx wrote: > From: Jitao Shi <jitao.shi@xxxxxxxxxxxx> > > In order to cooperate with patch 3/3 modification,it is necessary to > adjust > the position where mipi pulls up the signal. After the patch is applied, the series index (3/3) is disappear, so do not reference series index in commit description. I think this series is to adjust the calling sequence, so you could describe as below: Old sequence: 1. aaa 2. bbb 3. ccc 4. ddd New sequence: 1. bbb 2. aaa 3. ddd 4. ccc and this patch is to adjust 'aaa' and 'bbb'. Regards, CK > > Signed-off-by: Jitao Shi <jitao.shi@xxxxxxxxxxxx> > Signed-off-by: Xinlei Lee <xinlei.lee@xxxxxxxxxxxx> > --- > drivers/gpu/drm/mediatek/mtk_dsi.c | 6 +++--- > 1 file changed, 3 insertions(+), 3 deletions(-) > > diff --git a/drivers/gpu/drm/mediatek/mtk_dsi.c > b/drivers/gpu/drm/mediatek/mtk_dsi.c > index 5d90d2eb..6d7b66d 100644 > --- a/drivers/gpu/drm/mediatek/mtk_dsi.c > +++ b/drivers/gpu/drm/mediatek/mtk_dsi.c > @@ -649,14 +649,14 @@ static int mtk_dsi_poweron(struct mtk_dsi *dsi) > mtk_dsi_reset_engine(dsi); > mtk_dsi_phy_timconfig(dsi); > > - mtk_dsi_rxtx_control(dsi); > - usleep_range(30, 100); > - mtk_dsi_reset_dphy(dsi); > mtk_dsi_ps_control_vact(dsi); > mtk_dsi_set_vm_cmd(dsi); > mtk_dsi_config_vdo_timing(dsi); > mtk_dsi_set_interrupt_enable(dsi); > > + mtk_dsi_rxtx_control(dsi); > + usleep_range(30, 100); > + mtk_dsi_reset_dphy(dsi); > mtk_dsi_clk_ulp_mode_leave(dsi); > mtk_dsi_lane0_ulp_mode_leave(dsi); > mtk_dsi_clk_hs_mode(dsi, 0);
