* Tomi Valkeinen <tomi.valkeinen@xxxxxxxxxxxxxxxx> [210222 08:47]: > On 18/02/2021 07:57, Tony Lindgren wrote: > > Oh cool that you have those running again/still :) In this case there > > is no te-gpios if that might make a difference. > > No, GPIO TE is not used on OMAP4 SDP either. OK > >> So these errors start from the boot? Or only when running something > >> specific? > > > > They start from the boot when modules are loaded. > > Normally there are no updates happening unless an userspace app is > running, but I guess you have fb console enabled, with the blinking > cursor which makes the updates. > > I usually don't have fbcon enabled, but OMAP4 SDP works fine for me with > fbcon too... I'm using loadable modules with omap2plus_defconfig in case that makes a difference. Maybe there's some state preserved somewhere if deferred probe happens? > >> Is there a bootloader that initializes the display? > > > > Yes it boots with kexec. > > Is that open source? Can you disable the display setup from the > bootloader? Maybe the DSS or the panel is left into a state that for > whatever reason makes the kernel drivers break. Well that's a signed kernel booting kexec. But it has been working just fine for years now so I'd rather not blame that. > Or maybe a DSS or DSI reset via SYSCONFIG at probe would help, or panel > reset if it has such a feature. Maybe. But why would the $subject patch cause the errors? Regards, Tony _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
