On 5/15/20 11:24 AM, dillon min wrote:
> Hi Benjamin,
>
> thanks for reply.
>
> On Fri, May 15, 2020 at 4:31 PM Benjamin GAIGNARD
> <benjamin.gaignard@xxxxxx> wrote:
>>
>>
>> On 5/14/20 3:07 PM, dillon min wrote:
>>> Hi Alexandre,
>>>
>>> On Thu, May 14, 2020 at 8:53 PM Alexandre Torgue
>>> <alexandre.torgue@xxxxxx> wrote:
>>>>
>>>> On 5/14/20 10:24 AM, Linus Walleij wrote:
>>>>> On Tue, May 12, 2020 at 9:04 AM <dillon.minfei@xxxxxxxxx> wrote:
>>>>>
>>>>>> From: dillon min <dillon.minfei@xxxxxxxxx>
>>>>>>
>>>>>> Enable the ltdc & ili9341 on stm32429-disco board.
>>>>>>
>>>>>> Signed-off-by: dillon min <dillon.minfei@xxxxxxxxx>
>>>>> This mostly looks good but...
>>>>>
>>>>>> +&spi5 {
>>>>>> + status = "okay";
>>>>>> + pinctrl-0 = <&spi5_pins>;
>>>>>> + pinctrl-names = "default";
>>>>>> + #address-cells = <1>;
>>>>>> + #size-cells = <0>;
>>>>>> + cs-gpios = <&gpioc 2 GPIO_ACTIVE_LOW>;
>>>>>> + dmas = <&dma2 3 2 0x400 0x0>,
>>>>>> + <&dma2 4 2 0x400 0x0>;
>>>>>> + dma-names = "rx", "tx";
>>>>> These DMA assignments seem to be SoC things and should
>>>>> rather be in the DTS(I) file where &spi5 is defined, right?
>>>>> stm32f429.dtsi I suppose?
>>>> I agree with Linus, DMA have to be defined in SoC dtsi. And if a board
>>>> doesn't want to use it, we use the "delete-property".
>>> Yes, will move to Soc dtsi in next submits.
>>>
>>> i'm working on write a v4l2-m2m driver for dma2d of stm32 to support
>>> pixel conversion
>>> alpha blending between foreground and background graphics.
>>>
>>> as you know, some soc's engineer trying to add this function to drm system.
>>>
>>> do you know st's planning about soc's hardware accelerator driver on stm32mp?
>>> such as chrom-art, will add to drm subsystem via ioctl to access, or to v4l2,
>> On stm32mp we do not plan to use chrom-art in drm or v4l2 because it
>> does fit
>> with userland way of working. We use the GPU to do conversion, scaling,
>> blending
>> and composition in only one go.
>> As explain here [1] DRM subsytem it isn't a solution and v4l2-m2m isn't
>> used in any
>> mainline compositors like Weston or android surfaceflinger.
>>
>> Benjamin
>>
> After check stm32mp's datasheets, they don't have chrom-art ip inside. sorry for
> didn't check it yet.
>
> for stm32h7 series with chrom-art, jpeg hardware accelerator inside.
> does st has plan to
> setup a driver to support it ? i prefer v4l2-m2m should be easier to
> implement it.
> co work with dcmi, fbdev.
ST doesn't plan to create a driver for chrom-art because nothing in
mainline
userland could use it.
Benjamin
>
> thanks.
>
> best regards.
>
> Dillon
>> [1]
>> https://www.phoronix.com/scan.php?page=news_item&px=Linux-DRM-No-2D-Accel-API
>>> thanks.
>>>
>>>>> It is likely the same no matter which device is using spi5.
>>>>>
>>>>> Yours,
>>>>> Linus Walleij
>>>>>
>>> _______________________________________________
>>> Linux-stm32 mailing list
>>> Linux-stm32@xxxxxxxxxxxxxxxxxxxxxxxxxxxx
>>> https://st-md-mailman.stormreply.com/mailman/listinfo/linux-stm32
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
