On Tue, May 12, 2020 at 9:04 AM <dillon.minfei@xxxxxxxxx> wrote:
> From: dillon min <dillon.minfei@xxxxxxxxx>
>
> Enable the ltdc & ili9341 on stm32429-disco board.
>
> Signed-off-by: dillon min <dillon.minfei@xxxxxxxxx>
This mostly looks good but...
> +&spi5 {
> + status = "okay";
> + pinctrl-0 = <&spi5_pins>;
> + pinctrl-names = "default";
> + #address-cells = <1>;
> + #size-cells = <0>;
> + cs-gpios = <&gpioc 2 GPIO_ACTIVE_LOW>;
> + dmas = <&dma2 3 2 0x400 0x0>,
> + <&dma2 4 2 0x400 0x0>;
> + dma-names = "rx", "tx";
These DMA assignments seem to be SoC things and should
rather be in the DTS(I) file where &spi5 is defined, right?
stm32f429.dtsi I suppose?
It is likely the same no matter which device is using spi5.
Yours,
Linus Walleij
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
