Hi, Linus,
thanks for reviewing.
On Thu, May 14, 2020 at 4:24 PM Linus Walleij <linus.walleij@xxxxxxxxxx> wrote:
>
> On Tue, May 12, 2020 at 9:04 AM <dillon.minfei@xxxxxxxxx> wrote:
>
> > From: dillon min <dillon.minfei@xxxxxxxxx>
> >
> > Enable the ltdc & ili9341 on stm32429-disco board.
> >
> > Signed-off-by: dillon min <dillon.minfei@xxxxxxxxx>
>
> This mostly looks good but...
>
> > +&spi5 {
> > + status = "okay";
> > + pinctrl-0 = <&spi5_pins>;
> > + pinctrl-names = "default";
> > + #address-cells = <1>;
> > + #size-cells = <0>;
> > + cs-gpios = <&gpioc 2 GPIO_ACTIVE_LOW>;
> > + dmas = <&dma2 3 2 0x400 0x0>,
> > + <&dma2 4 2 0x400 0x0>;
> > + dma-names = "rx", "tx";
>
> These DMA assignments seem to be SoC things and should
> rather be in the DTS(I) file where &spi5 is defined, right?
> stm32f429.dtsi I suppose?
>
> It is likely the same no matter which device is using spi5.
>
> Yours,
> Linus Walleij
Yes, the dma assignments can be moved to stm32f429.dtsi file.
i will change it.
thanks.
best regards.
dillon,
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
