Re: [PATCH] drm/i915/dp: Add current maximum eDP link rate to sink_rate array.

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Jan 9, 2020 at 4:38 PM Ville Syrjälä <ville.syrjala@xxxxxxxxxxxxxxx> wrote:
On Thu, Jan 09, 2020 at 05:26:57PM +0200, Ville Syrjälä wrote:
> On Thu, Jan 09, 2020 at 04:07:52PM +0100, Mario Kleiner wrote:
> > The panel reports 10 bpc color depth in its EDID, and the UEFI
> > firmware chooses link settings at boot which support enough
> > bandwidth for 10 bpc (324000 kbit/sec to be precise), but the
> > DP_MAX_LINK_RATE dpcd register only reports 2.7 Gbps as possible,

Does it actually or do we just ignore the fact that it reports 3.24Gbps?

If it really reports 3.24 then we should be able to just add that to
dp_rates[] in intel_dp_set_sink_rates() and be done with it.

Although we'd likely want to skip 3.24 unless it really is reported
as the max so as to not use that non-standard rate on other displays.
So would require a bit fancier logic for that.


Was also my initial thought, but the DP_MAX_LINK_RATE reg reports 2.7 Gbps as maximum.
-mario

_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel

[Index of Archives]     [Linux DRI Users]     [Linux Intel Graphics]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]
  Powered by Linux