Fixes state transitions of Nvidia Pascal GPUs from D3cold into higher device
states.
v2: convert to pci_dev quirk
put a proper technical explanation of the issue as a in-code comment
v3: disable it only for certain combinations of intel and nvidia hardware
Signed-off-by: Karol Herbst <kherbst@xxxxxxxxxx>
Cc: Bjorn Helgaas <bhelgaas@xxxxxxxxxx>
Cc: Lyude Paul <lyude@xxxxxxxxxx>
Cc: Rafael J. Wysocki <rjw@xxxxxxxxxxxxx>
Cc: Mika Westerberg <mika.westerberg@xxxxxxxxx>
Cc: linux-pci@xxxxxxxxxxxxxxx
Cc: linux-pm@xxxxxxxxxxxxxxx
Cc: dri-devel@xxxxxxxxxxxxxxxxxxxxx
Cc: nouveau@xxxxxxxxxxxxxxxxxxxxx
---
drivers/pci/pci.c | 11 ++++++++++
drivers/pci/quirks.c | 52 ++++++++++++++++++++++++++++++++++++++++++++
include/linux/pci.h | 1 +
3 files changed, 64 insertions(+)
diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c
index b97d9e10c9cc..8e056eb7e6ff 100644
--- a/drivers/pci/pci.c
+++ b/drivers/pci/pci.c
@@ -805,6 +805,13 @@ static inline bool platform_pci_bridge_d3(struct pci_dev *dev)
return pci_platform_pm ? pci_platform_pm->bridge_d3(dev) : false;
}
+static inline bool parent_broken_child_pm(struct pci_dev *dev)
+{
+ if (!dev->bus || !dev->bus->self)
+ return false;
+ return dev->bus->self->broken_nv_runpm && dev->broken_nv_runpm;
+}
+
/**
* pci_raw_set_power_state - Use PCI PM registers to set the power state of
* given PCI device
@@ -850,6 +857,10 @@ static int pci_raw_set_power_state(struct pci_dev *dev, pci_power_t state)
|| (state == PCI_D2 && !dev->d2_support))
return -EIO;
+ /* check if the bus controller causes issues */
+ if (state != PCI_D0 && parent_broken_child_pm(dev))
+ return 0;
+
pci_read_config_word(dev, dev->pm_cap + PCI_PM_CTRL, &pmcsr);
/*
diff --git a/drivers/pci/quirks.c b/drivers/pci/quirks.c
index 44c4ae1abd00..c2f20b745dd4 100644
--- a/drivers/pci/quirks.c
+++ b/drivers/pci/quirks.c
@@ -5268,3 +5268,55 @@ static void quirk_reset_lenovo_thinkpad_p50_nvgpu(struct pci_dev *pdev)
DECLARE_PCI_FIXUP_CLASS_FINAL(PCI_VENDOR_ID_NVIDIA, 0x13b1,
PCI_CLASS_DISPLAY_VGA, 8,
quirk_reset_lenovo_thinkpad_p50_nvgpu);
+
+/*
+ * Some Intel PCIe bridges cause devices to disappear from the PCIe bus after
+ * those were put into D3cold state if they were put into a non D0 PCI PM
+ * device state before doing so.
+ *
+ * This leads to various issue different issues which all manifest differently,
+ * but have the same root cause:
+ * - AIML code execution hits an infinite loop (as the coe waits on device
+ * memory to change).
+ * - kernel crashes, as all pci reads return -1, which most code isn't able
+ * to handle well enough.
+ * - sudden shutdowns, as the kernel identified an unrecoverable error after
+ * userspace tries to access the GPU.
+ *
+ * In all cases dmesg will contain at least one line like this:
+ * 'nouveau 0000:01:00.0: Refused to change power state, currently in D3'
+ * followed by a lot of nouveau timeouts.
+ *
+ * ACPI code writes bit 0x80 to the not documented PCI register 0x248 of the
+ * PCIe bridge controller in order to power down the GPU.
+ * Nonetheless, there are other code paths inside the ACPI firmware which use
+ * other registers, which seem to work fine:
+ * - 0xbc bit 0x20 (publicly available documentation claims 'reserved')
+ * - 0xb0 bit 0x10 (link disable)
+ * Changing the conditions inside the firmware by poking into the relevant
+ * addresses does resolve the issue, but it seemed to be ACPI private memory
+ * and not any device accessible memory at all, so there is no portable way of
+ * changing the conditions.
+ *
+ * The only systems where this behavior can be seen are hybrid graphics laptops
+ * with a secondary Nvidia Pascal GPU. It cannot be ruled out that this issue
+ * only occurs in combination with listed Intel PCIe bridge controllers and
+ * the mentioned GPUs or if it's only a hw bug in the bridge controller.
+ *
+ * But because this issue was NOT seen on laptops with an Nvidia Pascal GPU
+ * and an Intel Coffee Lake SoC, there is a higher chance of there being a bug
+ * in the bridge controller rather than in the GPU.
+ *
+ * This issue was not able to be reproduced on non laptop systems.
+ */
+
+static void quirk_broken_nv_runpm(struct pci_dev *dev)
+{
+ dev->broken_nv_runpm = 1;
+}
+DECLARE_PCI_FIXUP_CLASS_FINAL(PCI_VENDOR_ID_NVIDIA, PCI_ANY_ID,
+ PCI_BASE_CLASS_DISPLAY, 16,
+ quirk_broken_nv_runpm);
+/* kaby lake */
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL, 0x1901,
+ quirk_broken_nv_runpm);
diff --git a/include/linux/pci.h b/include/linux/pci.h
index ac8a6c4e1792..903a0b3a39ec 100644
--- a/include/linux/pci.h
+++ b/include/linux/pci.h
@@ -416,6 +416,7 @@ struct pci_dev {
unsigned int __aer_firmware_first_valid:1;
unsigned int __aer_firmware_first:1;
unsigned int broken_intx_masking:1; /* INTx masking can't be used */
+ unsigned int broken_nv_runpm:1; /* some combinations of intel bridge controller and nvidia GPUs break rtd3 */
unsigned int io_window_1k:1; /* Intel bridge 1K I/O windows */
unsigned int irq_managed:1;
unsigned int has_secondary_link:1;
--
2.21.0
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
