On 12/14/2016 09:48 PM, Stefan Agner wrote: > The DRM subsystem specifies the pixel clock polarity from a > controllers perspective: DRM_BUS_FLAG_PIXDATA_NEGEDGE means > the controller drives the data on pixel clocks falling edge. > That is the controllers DOTCLK_POL=0 (Default is data launched > at negative edge). > > Also change the data enable logic to be high active by default > and only change if explicitly requested via bus_flags. With > that defaults are: > - Data enable: high active > - Pixel clock polarity: controller drives data on negative edge > > Signed-off-by: Stefan Agner <stefan@xxxxxxxx> Acked-by: Marek Vasut <marex@xxxxxxx> > --- > Changes since v1: > - Improved comments/fixed typo > > drivers/gpu/drm/mxsfb/mxsfb_crtc.c | 11 +++++++++-- > 1 file changed, 9 insertions(+), 2 deletions(-) > > diff --git a/drivers/gpu/drm/mxsfb/mxsfb_crtc.c b/drivers/gpu/drm/mxsfb/mxsfb_crtc.c > index 3770dd2..5556e53 100644 > --- a/drivers/gpu/drm/mxsfb/mxsfb_crtc.c > +++ b/drivers/gpu/drm/mxsfb/mxsfb_crtc.c > @@ -195,9 +195,16 @@ static void mxsfb_crtc_mode_set_nofb(struct mxsfb_drm_private *mxsfb) > vdctrl0 |= VDCTRL0_HSYNC_ACT_HIGH; > if (m->flags & DRM_MODE_FLAG_PVSYNC) > vdctrl0 |= VDCTRL0_VSYNC_ACT_HIGH; > - if (bus_flags & DRM_BUS_FLAG_DE_HIGH) > + /* Make sure Data Enable is high active by default */ > + if (!(bus_flags & DRM_BUS_FLAG_DE_LOW)) > vdctrl0 |= VDCTRL0_ENABLE_ACT_HIGH; > - if (bus_flags & DRM_BUS_FLAG_PIXDATA_NEGEDGE) > + /* > + * DRM_BUS_FLAG_PIXDATA_ defines are controller centric, > + * controllers VDCTRL0_DOTCLK is display centric. > + * Drive on positive edge -> display samples on falling edge > + * DRM_BUS_FLAG_PIXDATA_POSEDGE -> VDCTRL0_DOTCLK_ACT_FALLING > + */ > + if (bus_flags & DRM_BUS_FLAG_PIXDATA_POSEDGE) > vdctrl0 |= VDCTRL0_DOTCLK_ACT_FALLING; > > writel(vdctrl0, mxsfb->base + LCDC_VDCTRL0); > -- Best regards, Marek Vasut _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
