The DRM subsystem specifies the pixel clock polarity from a controllers perspective: DRM_BUS_FLAG_PIXDATA_NEGEDGE means the controller drives the data on pixel clocks falling edge. That is the controllers DOTCLK_POL=0 (Default is data launched at negative edge). Also change the data enable logic to be high active by default and only change if explicitly requested via bus_flags. With that defaults are: - Data enable: high active - Pixel clock polarity: controller drives data on negative edge Signed-off-by: Stefan Agner <stefan@xxxxxxxx> --- Changes since v1: - Improved comments/fixed typo drivers/gpu/drm/mxsfb/mxsfb_crtc.c | 11 +++++++++-- 1 file changed, 9 insertions(+), 2 deletions(-) diff --git a/drivers/gpu/drm/mxsfb/mxsfb_crtc.c b/drivers/gpu/drm/mxsfb/mxsfb_crtc.c index 3770dd2..5556e53 100644 --- a/drivers/gpu/drm/mxsfb/mxsfb_crtc.c +++ b/drivers/gpu/drm/mxsfb/mxsfb_crtc.c @@ -195,9 +195,16 @@ static void mxsfb_crtc_mode_set_nofb(struct mxsfb_drm_private *mxsfb) vdctrl0 |= VDCTRL0_HSYNC_ACT_HIGH; if (m->flags & DRM_MODE_FLAG_PVSYNC) vdctrl0 |= VDCTRL0_VSYNC_ACT_HIGH; - if (bus_flags & DRM_BUS_FLAG_DE_HIGH) + /* Make sure Data Enable is high active by default */ + if (!(bus_flags & DRM_BUS_FLAG_DE_LOW)) vdctrl0 |= VDCTRL0_ENABLE_ACT_HIGH; - if (bus_flags & DRM_BUS_FLAG_PIXDATA_NEGEDGE) + /* + * DRM_BUS_FLAG_PIXDATA_ defines are controller centric, + * controllers VDCTRL0_DOTCLK is display centric. + * Drive on positive edge -> display samples on falling edge + * DRM_BUS_FLAG_PIXDATA_POSEDGE -> VDCTRL0_DOTCLK_ACT_FALLING + */ + if (bus_flags & DRM_BUS_FLAG_PIXDATA_POSEDGE) vdctrl0 |= VDCTRL0_DOTCLK_ACT_FALLING; writel(vdctrl0, mxsfb->base + LCDC_VDCTRL0); -- 2.10.2 _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
