On 04/04/21 04:24PM, Péter Ujfalusi wrote:
> Hi Pratyush,
>
> On 3/30/21 8:33 PM, Pratyush Yadav wrote:
> > The CSI2RX subsystem uses PSI-L DMA to transfer frames to memory. It can
> > have up to 32 threads but the current driver only supports using one. So
> > add an entry for that one thread.
>
> If you are absolutely sure that the other threads are not going to be
> used, then:
The opposite in fact. I do expect other threads to be used in the
future. But the current driver can only use one so I figured it is
better to add just the thread that is currently needed and then I can
always add the rest later.
Why does this have to be a one-and-done deal? Is there anything wrong
with adding the other threads when the driver can actually use them?
> Acked-by: Peter Ujfalusi <peter.ujfalusi@xxxxxxxxx>
>
> but I would consider adding the other threads if there is a chance that
> the cs2rx will need to support it in the future.
>
> > Signed-off-by: Pratyush Yadav <p.yadav@xxxxxx>
> > ---
> > drivers/dma/ti/k3-psil-j721e.c | 10 ++++++++++
> > 1 file changed, 10 insertions(+)
> >
> > diff --git a/drivers/dma/ti/k3-psil-j721e.c b/drivers/dma/ti/k3-psil-j721e.c
> > index 7580870ed746..19ffa31e6dc6 100644
> > --- a/drivers/dma/ti/k3-psil-j721e.c
> > +++ b/drivers/dma/ti/k3-psil-j721e.c
> > @@ -58,6 +58,14 @@
> > }, \
> > }
> >
> > +#define PSIL_CSI2RX(x) \
> > + { \
> > + .thread_id = x, \
> > + .ep_config = { \
> > + .ep_type = PSIL_EP_NATIVE, \
> > + }, \
> > + }
> > +
> > /* PSI-L source thread IDs, used for RX (DMA_DEV_TO_MEM) */
> > static struct psil_ep j721e_src_ep_map[] = {
> > /* SA2UL */
> > @@ -138,6 +146,8 @@ static struct psil_ep j721e_src_ep_map[] = {
> > PSIL_PDMA_XY_PKT(0x4707),
> > PSIL_PDMA_XY_PKT(0x4708),
> > PSIL_PDMA_XY_PKT(0x4709),
> > + /* CSI2RX */
> > + PSIL_CSI2RX(0x4940),
> > /* CPSW9 */
> > PSIL_ETHERNET(0x4a00),
> > /* CPSW0 */
> >
>
> --
> Péter
--
Regards,
Pratyush Yadav
Texas Instruments Inc.
