On Wed, 16 Sep 2015, Charles Keepax wrote: > Add additional bindings for both inverting the polarity of the jack > detection pins and allowing the use of a second jack detection pin. Note > that the second jack detection pin is hard wired in the chip so can only > be enabled through the binding, rather than a pin being specified. > > Signed-off-by: Charles Keepax <ckeepax@xxxxxxxxxxxxxxxxxxxxxxxxxxx> > Reviewed-by: Chanwoo Choi <cw00.choi@xxxxxxxxxxx> > --- > Documentation/devicetree/bindings/mfd/arizona.txt | 6 ++++++ > 1 files changed, 6 insertions(+), 0 deletions(-) > > diff --git a/Documentation/devicetree/bindings/mfd/arizona.txt b/Documentation/devicetree/bindings/mfd/arizona.txt > index b98a11b..cb3a652 100644 > --- a/Documentation/devicetree/bindings/mfd/arizona.txt > +++ b/Documentation/devicetree/bindings/mfd/arizona.txt > @@ -73,6 +73,12 @@ Optional properties: > If this node is not mentioned or if the value is unknown, then > headphone detection mode is set to HPDETL. > > + - wlf,use-jd-gpio : Use GPIO input along with JD1 for dual pin jack > + detection. > + - wlf,use-jd-gpio-nopull : Internal pull on GPIO is disabled when used for > + jack detection. > + - wlf,jd-invert : Invert the polarity of the jack detection switch As before, I need an Ack from one of the DT guys, or perhaps Linus W. > - wlf,micd-software-compare : Use a software comparison to determine mic > presence > - wlf,micd-detect-debounce : Additional software microphone detection -- Lee Jones Linaro STMicroelectronics Landing Team Lead Linaro.org │ Open source software for ARM SoCs Follow Linaro: Facebook | Twitter | Blog -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html