Add additional bindings for both inverting the polarity of the jack
detection pins and allowing the use of a second jack detection pin. Note
that the second jack detection pin is hard wired in the chip so can only
be enabled through the binding, rather than a pin being specified.
Signed-off-by: Charles Keepax <ckeepax@xxxxxxxxxxxxxxxxxxxxxxxxxxx>
Reviewed-by: Chanwoo Choi <cw00.choi@xxxxxxxxxxx>
---
Documentation/devicetree/bindings/mfd/arizona.txt | 6 ++++++
1 files changed, 6 insertions(+), 0 deletions(-)
diff --git a/Documentation/devicetree/bindings/mfd/arizona.txt b/Documentation/devicetree/bindings/mfd/arizona.txt
index b98a11b..cb3a652 100644
--- a/Documentation/devicetree/bindings/mfd/arizona.txt
+++ b/Documentation/devicetree/bindings/mfd/arizona.txt
@@ -73,6 +73,12 @@ Optional properties:
If this node is not mentioned or if the value is unknown, then
headphone detection mode is set to HPDETL.
+ - wlf,use-jd-gpio : Use GPIO input along with JD1 for dual pin jack
+ detection.
+ - wlf,use-jd-gpio-nopull : Internal pull on GPIO is disabled when used for
+ jack detection.
+ - wlf,jd-invert : Invert the polarity of the jack detection switch
+
- wlf,micd-software-compare : Use a software comparison to determine mic
presence
- wlf,micd-detect-debounce : Additional software microphone detection
--
1.7.2.5
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
