On Fri, 2025-02-28 at 11:23 -0600, Rob Herring wrote: > On Fri, Feb 28, 2025 at 10:46 AM Eddie James <eajames@xxxxxxxxxxxxx> > wrote: > > > > > > On 2/24/25 22:34, Andrew Jeffery wrote: > > > On Fri, 2025-02-21 at 12:11 -0600, Rob Herring (Arm) wrote: > > > > On Thu, 20 Feb 2025 14:59:45 -0600, Eddie James wrote: > > > > > The Balcones system is similar to Bonnell but with a POWER11 > > > > > processor. > > > > > > > > > > Changes since v1: > > > > > - Add all the ucd9000 driver supported compatible strings > > > > > - Fix node ordering in Balcones device tree > > > > > - Improve commit message to explain addition of ibm- > > > > > power11-dual.dtsi > > > > > > > > > > Eddie James (3): > > > > > dt-bindings: arm: aspeed: add IBM Balcones board > > > > > dt-bindings: hwmon: ucd90320: Add additional compatible > > > > > strings > > > > > ARM: dts: aspeed: Add Balcones system > > > > > > > > > > .../bindings/arm/aspeed/aspeed.yaml | 1 + > > > > > .../bindings/hwmon/pmbus/ti,ucd90320.yaml | 6 + > > > > > arch/arm/boot/dts/aspeed/Makefile | 1 + > > > > > .../dts/aspeed/aspeed-bmc-ibm-balcones.dts | 594 > > > > > +++++++++++++ > > > > > .../arm/boot/dts/aspeed/ibm-power11-dual.dtsi | 779 > > > > > ++++++++++++++++++ > > > > > .../arm/boot/dts/aspeed/ibm-power11-quad.dtsi | 769 +------ > > > > > ---------- > > > > > 6 files changed, 1383 insertions(+), 767 deletions(-) > > > > > create mode 100644 arch/arm/boot/dts/aspeed/aspeed-bmc-ibm- > > > > > balcones.dts > > > > > create mode 100644 arch/arm/boot/dts/aspeed/ibm-power11- > > > > > dual.dtsi > > > > > > > > > > -- > > > > > 2.43.5 > > > > > > > > > > > > > > > > > > > > > > > My bot found new DTB warnings on the .dts files added or > > > > changed in this > > > > series. > > > > > > > ... > > > > > > > arch/arm/boot/dts/aspeed/aspeed-bmc-ibm-balcones.dtb: > > > > gpio@1e780000: 'usb-power-hog' does not match any of the > > > > regexes: 'pinctrl-[0-9]+' > > > > from schema $id: > > > > http://devicetree.org/schemas/gpio/aspeed,ast2400-gpio.yaml# > > > Ah, can you address this one? > > > > > > > arch/arm/boot/dts/aspeed/aspeed-bmc-ibm-balcones.dtb: > > > > /ahb/apb/bus@1e78a000/i2c@400/pwm@53: failed to match any > > > > schema with compatible: ['maxim,max31785a'] > > > > arch/arm/boot/dts/aspeed/aspeed-bmc-ibm-balcones.dtb: > > > > pressure-sensor@76: '#io-channel-cells' does not match any of > > > > the regexes: 'pinctrl-[0-9]+' > > > > from schema $id: > > > > http://devicetree.org/schemas/trivial-devices.yaml# > > > And these also? > > > > > > The rest looked like the usual noise. > > > > > > Well, all of these errors are also present in Blueridge. I would > > need to > > write a new binding for dps310, move max31785 to yaml format, and > > I'm > > not sure how to fix the gpio hog one. I don't see that error when I > > run > > CHECK_DTBS myself... any suggestions? > > I think the hog one got fixed recently. The tests run on top of > whatever b4 picks for the base or linux-next if it can't figure out > the base. So that might be the difference. Eddie: Yeah, disregard the hog one. An alternative to writing/converting the bindings is dropping the relevant nodes for now, and adding them back once the bindings have been dealt with. Up to you. Andrew
