On 11/03/2025 18:59, Rob Herring wrote: > On Tue, Mar 11, 2025 at 09:42:45AM +0100, Krzysztof Kozlowski wrote: >> On Fri, Mar 07, 2025 at 02:52:42PM +0100, Francesco Dolcini wrote: >>> From: Ernest Van Hoecke <ernest.vanhoecke@xxxxxxxxxxx> >>> >>> Add two properties to select the IN1L/DMICDAT1 and IN2R/DMICDAT2 >>> functionality: >>> - wlf,in1l-as-dmicdat1 >>> - wlf,in1r-as-dmicdat2 >>> >>> Add a property to describe the GPIO configuration registers, that can be >>> used to set the four multifunction pins: >>> - wlf,gpio-cfg >>> >>> Add a property to describe the mic bias control registers: >>> - wlf,mic-cfg >>> >>> Add two properties to describe the Dynamic Range Controller (DRC), >>> allowing multiple named configurations where each config sets the 4 DRC >>> registers (R40-R43): >>> - wlf,drc-cfg-regs >>> - wlf,drc-cfg-names >>> >>> Add three properties to describe the equalizer (ReTune Mobile), allowing >>> multiple named configurations (associated with a samplerate) that set >>> the 24 (R134-R157) EQ registers: >>> - wlf,retune-mobile-cfg-regs >>> - wlf,retune-mobile-cfg-hz >>> - wlf,retune-mobile-cfg-rates > > >>> + * Config registers per name, respectively: >>> + * KNEE_IP = 0, KNEE_OP = 0, HI_COMP = 1, LO_COMP = 1 >>> + * KNEE_IP = -24, KNEE_OP = -6, HI_COMP = 1/4, LO_COMP = 1 >>> + * KNEE_IP = -42, KNEE_OP = -3, HI_COMP = 0, LO_COMP = 1 >>> + * KNEE_IP = -45, KNEE_OP = -9, HI_COMP = 1/8, LO_COMP = 1 >>> + * KNEE_IP = -30, KNEE_OP = -10.5, HI_COMP = 1/4, LO_COMP = 1 >>> + */ >>> + wlf,drc-cfg-regs = /bits/ 16 <0x01af 0x3248 0x0000 0x0000>, >> >> <number>, <number>, <number> ... >> >> unless you wanted 64-bit? > > Why? You would need "/bits/ 16 <number>, /bits/ 16 <number>, ..." Uh, right. Best regards, Krzysztof
