On Tue, Mar 11, 2025 at 09:42:45AM +0100, Krzysztof Kozlowski wrote: > On Fri, Mar 07, 2025 at 02:52:42PM +0100, Francesco Dolcini wrote: > > From: Ernest Van Hoecke <ernest.vanhoecke@xxxxxxxxxxx> > > > > Add two properties to select the IN1L/DMICDAT1 and IN2R/DMICDAT2 > > functionality: > > - wlf,in1l-as-dmicdat1 > > - wlf,in1r-as-dmicdat2 > > > > Add a property to describe the GPIO configuration registers, that can be > > used to set the four multifunction pins: > > - wlf,gpio-cfg > > > > Add a property to describe the mic bias control registers: > > - wlf,mic-cfg > > > > Add two properties to describe the Dynamic Range Controller (DRC), > > allowing multiple named configurations where each config sets the 4 DRC > > registers (R40-R43): > > - wlf,drc-cfg-regs > > - wlf,drc-cfg-names > > > > Add three properties to describe the equalizer (ReTune Mobile), allowing > > multiple named configurations (associated with a samplerate) that set > > the 24 (R134-R157) EQ registers: > > - wlf,retune-mobile-cfg-regs > > - wlf,retune-mobile-cfg-hz > > - wlf,retune-mobile-cfg-rates > > + * Config registers per name, respectively: > > + * KNEE_IP = 0, KNEE_OP = 0, HI_COMP = 1, LO_COMP = 1 > > + * KNEE_IP = -24, KNEE_OP = -6, HI_COMP = 1/4, LO_COMP = 1 > > + * KNEE_IP = -42, KNEE_OP = -3, HI_COMP = 0, LO_COMP = 1 > > + * KNEE_IP = -45, KNEE_OP = -9, HI_COMP = 1/8, LO_COMP = 1 > > + * KNEE_IP = -30, KNEE_OP = -10.5, HI_COMP = 1/4, LO_COMP = 1 > > + */ > > + wlf,drc-cfg-regs = /bits/ 16 <0x01af 0x3248 0x0000 0x0000>, > > <number>, <number>, <number> ... > > unless you wanted 64-bit? Why? You would need "/bits/ 16 <number>, /bits/ 16 <number>, ..." Rob
