From: Stefan Eichenberger <stefan.eichenberger@xxxxxxxxxxx>
The current solution for powering off the Apalis iMX6 is not functioning
as intended. To resolve this, it is necessary to power off the
vgen2_reg, which will also set the POWER_ENABLE_MOCI signal to a low
state. This ensures the carrier board is properly informed to initiate
its power-off sequence.
The new solution uses the regulator-poweroff driver, which will power
off the regulator during a system shutdown.
CC: stable@xxxxxxxxxxxxxxx
Fixes: 4eb56e26f92e ("ARM: dts: imx6q-apalis: Command pmic to standby for poweroff")
Signed-off-by: Stefan Eichenberger <stefan.eichenberger@xxxxxxxxxxx>
---
arch/arm/boot/dts/nxp/imx/imx6qdl-apalis.dtsi | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/arch/arm/boot/dts/nxp/imx/imx6qdl-apalis.dtsi b/arch/arm/boot/dts/nxp/imx/imx6qdl-apalis.dtsi
index 1c72da417011..614b65821995 100644
--- a/arch/arm/boot/dts/nxp/imx/imx6qdl-apalis.dtsi
+++ b/arch/arm/boot/dts/nxp/imx/imx6qdl-apalis.dtsi
@@ -108,6 +108,11 @@ lvds_panel_in: endpoint {
};
};
+ poweroff {
+ compatible = "regulator-poweroff";
+ cpu-supply = <&vgen2_reg>;
+ };
+
reg_module_3v3: regulator-module-3v3 {
compatible = "regulator-fixed";
regulator-always-on;
@@ -236,10 +241,6 @@ &can2 {
status = "disabled";
};
-&clks {
- fsl,pmic-stby-poweroff;
-};
-
/* Apalis SPI1 */
&ecspi1 {
cs-gpios = <&gpio5 25 GPIO_ACTIVE_LOW>;
@@ -527,7 +528,6 @@ &i2c2 {
pmic: pmic@8 {
compatible = "fsl,pfuze100";
- fsl,pmic-stby-poweroff;
reg = <0x08>;
regulators {
--
2.45.2
