On Thu, 2 Apr 2015 20:50:08 +0200 Maxime Ripard <maxime.ripard@xxxxxxxxxxxxxxxxxx> wrote: > On Tue, Mar 31, 2015 at 10:31:20PM +0300, Aleksei Mamlin wrote: > > > > + compatible = "goodix,gt911"; > > > > + reg = <0x5d>; > > > > + interrupt-parent = <&pio>; > > > > + interrupts = <21 IRQ_TYPE_NONE>; /* EINT21 (PH21) */ > > > > > > Unfortunately, IRQ_TYPE_NONE is not a valid value for the GIC > > > bindings. > > > > > > > Hmm. Which value I must use in this case? IRQ type is set by the > > touchscreen controller driver, so I think that value must be 0. > > Whatever the hardware is using. Presumably the same value than the > driver sets. > > > > > > > You're also not adding a pinctrl group for that pin? > > > > No, because it works fine with this DT nodes. It seems that I should > > first configure pin to work in interrupt mode. Correct? > > You don't have to, since the pio driver will already take care of > muxing it to the right function, but that will prevent any driver to > call pinctrl_request on the same pin. > It is still necessary? I see that you have accepted Hans de Goede's patches: http://www.spinics.net/lists/arm-kernel/msg411142.html > > Maxime > > -- > Maxime Ripard, Free Electrons > Embedded Linux, Kernel and Android engineering > http://free-electrons.com -- Thanks and regards, Aleksei Mamlin -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
