Re: [PATCH] ARM: dts: sun7i: Add Goodix GT911 nodes for Wexler TAB7200

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On Thu, 2 Apr 2015 11:22:59 +0200
Maxime Ripard <maxime.ripard@xxxxxxxxxxxxxxxxxx> wrote:

> On Tue, Mar 31, 2015 at 10:14:20PM +0300, Aleksei Mamlin wrote:
> > On Tue, 31 Mar 2015 07:43:38 -0700
> > Maxime Ripard <maxime.ripard@xxxxxxxxxxxxxxxxxx> wrote:
> > 
> > > Hi,
> > > 
> > > On Tue, Mar 31, 2015 at 11:18:17AM +0300, Aleksei Mamlin wrote:
> > > > This patch adds nodes for the Goodix GT911 touchscreen controller found
> > > > on the Wexler TAB7200 tablet. Controller uses one of following I2C
> > > > addresses: 0x5d or 0x14, so just add two nodes.
> > > 
> > > In which case are these different addresses encountered? Different
> > > revisions of the same board?
> >
> > According to the datasheet it is a feature of the controller. 
> > The address(0x5d or 0x14) can be configured using a reset sequence,
> > which has not yet been implemented in the driver.
> 
> Which address is set up by the bootloader then?
> 
I assume that bootloader(u-boot) didn't sets up any address, but touchscreen
controller usually uses 0x5d. Sometimes, after hard reset, it uses 0x14.
For this we need nodes on both adresses.
>
> Maxime
> 
> -- 
> Maxime Ripard, Free Electrons
> Embedded Linux, Kernel and Android engineering
> http://free-electrons.com


-- 
Thanks and regards,
Aleksei Mamlin
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux