[PATCH 1/3] dt-bindings: iio: adc: adi,ad7124: Allow specifications of a gpio for irq line

[Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxx>]

For the AD7124 chip the logical irq line (̅R̅D̅Y) is physically on the same
pin as the spi MISO output (DOUT) and so reading a register might
trigger an interrupt. For correct operation it's critical that the
actual state of the pin can be read to judge if an interrupt event is a
real one or just a spurious one triggered by toggling the line in its
MISO mode.

Allow specification of an "interrupt-gpios" property instead of a plain
interrupt. The semantic is that the GPIO's interrupt is to be used as
event source and reading the GPIO can be used to differentiate between a
real event and one triggered by MISO.

Signed-off-by: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxx>
---
 .../devicetree/bindings/iio/adc/adi,ad7124.yaml     | 13 ++++++++++---
 1 file changed, 10 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/iio/adc/adi,ad7124.yaml b/Documentation/devicetree/bindings/iio/adc/adi,ad7124.yaml
index 35ed04350e28..feb3a41a148e 100644
--- a/Documentation/devicetree/bindings/iio/adc/adi,ad7124.yaml
+++ b/Documentation/devicetree/bindings/iio/adc/adi,ad7124.yaml
@@ -37,6 +37,9 @@ properties:
     description: IRQ line for the ADC
     maxItems: 1
 
+  interrupt-gpios:
+    description: GPIO reading the interrupt line
+
   '#address-cells':
     const: 1
 
@@ -57,7 +60,12 @@ required:
   - reg
   - clocks
   - clock-names
-  - interrupts
+
+oneOf:
+  - required:
+      - interrupts
+  - required:
+      - interrupt-gpios
 
 patternProperties:
   "^channel@([0-9]|1[0-5])$":
@@ -119,8 +127,7 @@ examples:
         compatible = "adi,ad7124-4";
         reg = <0>;
         spi-max-frequency = <5000000>;
-        interrupts = <25 2>;
-        interrupt-parent = <&gpio>;
+        interrupt-gpios = <&gpio 25 2>;
         refin1-supply = <&adc_vref>;
         clocks = <&ad7124_mclk>;
         clock-names = "mclk";
-- 
2.45.2