On Thu, 24 Oct 2024 19:17:03 +0200 Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxx> wrote: > For the AD7124 chip the logical irq line (̅R̅D̅Y) is physically on the same > pin as the spi MISO output (DOUT) and so reading a register might > trigger an interrupt. For correct operation it's critical that the > actual state of the pin can be read to judge if an interrupt event is a > real one or just a spurious one triggered by toggling the line in its > MISO mode. This text should note that this is a limitation with the interrupt controller. The IRQ is disabled when those reads are going on, yet the controller is still detecting the interrupt and reporting it on reenable. I'm not an expert in what the kernel IRQ subsystem requires so maybe this is a valid implementation. > > Allow specification of an "interrupt-gpios" property instead of a plain > interrupt. The semantic is that the GPIO's interrupt is to be used as > event source and reading the GPIO can be used to differentiate between a > real event and one triggered by MISO. This sort of hack is a bit nasty and if we are going to do it we should allow for double wiring - so to separate GPIO and interrupt pins on the host wired to single pin on the device. The binding does that by allowing both interrupts and interrupt-gpio but we need to make that explicit in this text. Arguably even when they are the same pin the binding should treat them as independent and the driver should get the gpio from one, and the interrupt from the other. I also definitely need input from Analog Devices folk on this series. Jonathan > > Signed-off-by: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxx> > --- > .../devicetree/bindings/iio/adc/adi,ad7124.yaml | 13 ++++++++++--- > 1 file changed, 10 insertions(+), 3 deletions(-) > > diff --git a/Documentation/devicetree/bindings/iio/adc/adi,ad7124.yaml b/Documentation/devicetree/bindings/iio/adc/adi,ad7124.yaml > index 35ed04350e28..feb3a41a148e 100644 > --- a/Documentation/devicetree/bindings/iio/adc/adi,ad7124.yaml > +++ b/Documentation/devicetree/bindings/iio/adc/adi,ad7124.yaml > @@ -37,6 +37,9 @@ properties: > description: IRQ line for the ADC > maxItems: 1 > > + interrupt-gpios: > + description: GPIO reading the interrupt line > + > '#address-cells': > const: 1 > > @@ -57,7 +60,12 @@ required: > - reg > - clocks > - clock-names > - - interrupts > + > +oneOf: > + - required: > + - interrupts > + - required: > + - interrupt-gpios > > patternProperties: > "^channel@([0-9]|1[0-5])$": > @@ -119,8 +127,7 @@ examples: > compatible = "adi,ad7124-4"; > reg = <0>; > spi-max-frequency = <5000000>; > - interrupts = <25 2>; > - interrupt-parent = <&gpio>; > + interrupt-gpios = <&gpio 25 2>; > refin1-supply = <&adc_vref>; > clocks = <&ad7124_mclk>; > clock-names = "mclk";
