On 10/16/24 4:22 PM, Anand Moon wrote:
> Hi Damien,
>
> On Wed, 16 Oct 2024 at 11:45, Damien Le Moal <dlemoal@xxxxxxxxxx> wrote:
>>
>> On 10/16/24 2:32 PM, Anand Moon wrote:
>>> Hi Damien,
>>>
>>> On Fri, 11 Oct 2024 at 17:55, Damien Le Moal <dlemoal@xxxxxxxxxx> wrote:
>>>>
>>>> This patch series fix the PCI address mapping handling of the Rockchip
>>>> endpoint driver, refactor some of its code, improves link training and
>>>> adds handling of the #PERST signal.
>>>>
>>>> This series is organized as follows:
>>>> - Patch 1 fixes the rockchip ATU programming
>>>> - Patch 2, 3 and 4 introduce small code improvments
>>>> - Patch 5 implements the .get_mem_map() operation to make the RK3399
>>>> endpoint controller driver fully functional with the new
>>>> pci_epc_mem_map() function
>>>> - Patch 6, 7, 8 and 9 refactor the driver code to make it more readable
>>>> - Patch 10 introduces the .stop() endpoint controller operation to
>>>> correctly disable the endpopint controller after use
>>>> - Patch 11 improves link training
>>>> - Patch 12 implements handling of the #PERST signal
>>>>
>>>> This patch series depends on the PCI endpoint core patches from the
>>>> V5 series "Improve PCI memory mapping API". The patches were tested
>>>> using a Pine Rockpro64 board used as an endpoint with the test endpoint
>>>> function driver and a prototype nvme endpoint function driver.
>>>
>>> Can we test this feature on Radxa Rock PI 4b hardware with an external
>>> nvme card?
>>
>> This patch series is to fix the PCI controller operation in endpoint (EP) mode.
>> If you only want to use an NVMe device connected to the board M.2 M-Key slot,
>> these patches are not needed. If that board PCI controller does not work as a
>> PCI host (RC mode), then these patches will not help.
>>
>
> Thanks for your inputs, I don't think my board supports this feature.
The Rock 4B board uses a RK3399 SoC. So the PCIe port should work as long as
you have the right device tree for the board. The mainline kernel currently has
this DT:
rk3399-rock-pi-4b.dts
Which uses
rk3399-rock-pi-4.dtsi
which has:
&pcie0 {
ep-gpios = <&gpio4 RK_PD3 GPIO_ACTIVE_HIGH>;
num-lanes = <4>;
pinctrl-0 = <&pcie_clkreqnb_cpm>;
pinctrl-names = "default";
vpcie0v9-supply = <&vcc_0v9>;
vpcie1v8-supply = <&vcc_1v8>;
vpcie3v3-supply = <&vcc3v3_pcie>;
status = "okay";
};
So it looks to me like the PCIe port is supported just fine. FOr the PCIe port
node definition look at rk3399.dtsi and rk3399-base.dtsi.
--
Damien Le Moal
Western Digital Research
