Re: [PATCH v2 1/1] arm64: dts: ti: k3-am62-wakeup: Configure ti-sysc for wkup_uart0

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



* Nishanth Menon <nm@xxxxxx> [231215 16:00]:
> On 09:32-20231114, Tony Lindgren wrote:
> > -	wkup_uart0: serial@2b300000 {
> > -		compatible = "ti,am64-uart", "ti,am654-uart";
> > -		reg = <0x00 0x2b300000 0x00 0x100>;
> > -		interrupts = <GIC_SPI 186 IRQ_TYPE_LEVEL_HIGH>;
> > +	target-module@2b300000 {
> 
> should be  target-module@2b300050 to match up with reg?

It's best to use the target-module IO range here, not the first reg.
The first reg may be tossed anywhere in the target module address
space depending on the device.

Ideally of course there would be just a standardized range of target
module related registers at the end of the IO space..

> > +		wkup_uart0: serial@2b300000 {
> 
> serial@0  to match up with reg?

Yes thanks for catching this. The 8250 IP is at the beginning of the
target module IO space. Will post an updated patch.

Regards,

Tony




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux