On 10/26/23 21:04, Caleb Connolly wrote:
On 26/10/2023 19:56, Konrad Dybcio wrote:
On 10/25/23 13:58, Caleb Connolly wrote:
The default for the QCM2290 platform that this board is based on is OTG
mode, however the role detection logic is not hooked up for this board
and the dwc3 driver is configured to not allow role switching from
userspace.
Force this board to host mode as this is the preferred usecase until we
get role switching hooked up.
Does that not kill usb internet and similar?
like rndis gadget? yes, it does kill that. But in return you get real
ethernet ;P
This is the preferred default configuration for these boards (I sent a
similar patch for rb2 before). The usb_role framework does have support
for letting userspace change the role via sysfs, but it's disabled for
dwc3. The plan is to enable role switching properly by reading the DIP
switch state in the future.
Ok all that sounds reasonable
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
Konrad
