On Mon, 23 Oct 2023 16:36:35 +0200, Oleksij Rempel wrote: > If I see it correctly, in both cases there is only one bit to configure > direction. The code need to support two interface modes: > - PHY_INTERFACE_MODE_RMII (MAC mode) PLL is the clock provider. REFCLKO > is used. > - PHY_INTERFACE_MODE_REVRMII (PHY mode) PLL is not used, REFCLKI is the clock provider. As you suggested, it looks like KSZ9897 clocking mode depends on RMII interface mode (with strapping pins), but I don't see this for KSZ8863. The PHY/MAC mode is selected with Register 0x35 bit 7 and the clocking mode is selected via strapping pins EN_REFCLKO and SMTXD32 (and additional register 0xC6 bit 3). I guess its possible for the KSZ8863 to be the clock provider/consumer regardless of PHY/MAC mode? Table 3-5: RMII CLOCK SETTING of KSZ8863 datasheet describes the available clocking modes. If we try to create a relation between KSZ9897 and KSZ8863: KSZ9897 "Normal Mode" is equivalent to KSZ8863 mode described in first column of table 3-5: - EN_REFCLKO = 0, 0xC6(3) = 0 -> external 50Mhz OSC input to REFCLKI and X1 pin directly KSZ9897 "Clock Mode" is equivalent to KSZ8863 mode described in fourth/fifth column (difference is only clock frequency) of table 3-5: - EN_REFCLKO = 1, 0xC6(3) = 1 -> 50/25Mhz on X1 pin, 50/25Mhz RMII clock goes to REFCLKI internally. REFCLKI can be pulled down by resistor. That leaves us with additional columns 2 and 3 of table 3-5 for KSZ8863, that are similar to KSZ9897 Clock mode, but REFCLKI needs to be fed externally from REFCLKO. > I already did some work to configure CPU interface, where which can be at least > partially reused for your work: > https://lore.kernel.org/all/20230517121034.3801640-2-o.rempel@xxxxxxxxxxxxxx/ > (Looks I forgot to complete mainlining for this patch) > > If implanted as described, no new devicetree properties will be needed. I don't quite get how the proposed patch might effect this topic? By setting PHY/MAC mode? As noted, I dont see the same relation between clock and MII mode for KSZ8863 as for KSZ9897?
