On Thu, May 18, 2023 at 12:37:59PM +0100, Srinivas Kandagatla wrote:
> Add support for the lpass audio clock controller found on SC8280XP based
> devices. This would allow lpass peripheral loader drivers to control the
> clocks and bring the subsystems out of reset.
>
> Currently this patch only supports resets as the Q6DSP is in control of
> LPASS IP which manages most of the clocks via Q6PRM service on GPR rpmsg
> channel.
>
> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx>
> ---
> drivers/clk/qcom/lpasscc-sc8280xp.c | 23 +++++++++++++++++++++++
> 1 file changed, 23 insertions(+)
>
> diff --git a/drivers/clk/qcom/lpasscc-sc8280xp.c b/drivers/clk/qcom/lpasscc-sc8280xp.c
> index 118320f8ee40..e221ae2d40ae 100644
> --- a/drivers/clk/qcom/lpasscc-sc8280xp.c
> +++ b/drivers/clk/qcom/lpasscc-sc8280xp.c
> @@ -13,6 +13,26 @@
> #include "common.h"
> #include "reset.h"
>
> +static const struct qcom_reset_map lpass_audio_csr_sc8280xp_resets[] = {
> + [LPASS_AUDIO_SWR_RX_CGCR] = { 0xa0, 1 },
> + [LPASS_AUDIO_SWR_WSA_CGCR] = { 0xb0, 1 },
> + [LPASS_AUDIO_SWR_WSA2_CGCR] = { 0xd8, 1 },
> +};
> +
> +static struct regmap_config lpass_audio_csr_sc8280xp_regmap_config = {
> + .reg_bits = 32,
> + .reg_stride = 4,
> + .val_bits = 32,
> + .name = "lpass-audio-csr",
Should you update this name to match the new compatible
("lpassaudiocc")?
> + .max_register = 0x1000,
> +};
> +
> +static const struct qcom_cc_desc lpass_audio_csr_reset_sc8280xp_desc = {
Same here (and for the reset struct as well as previous patch).
> + .config = &lpass_audio_csr_sc8280xp_regmap_config,
> + .resets = lpass_audio_csr_sc8280xp_resets,
> + .num_resets = ARRAY_SIZE(lpass_audio_csr_sc8280xp_resets),
> +};
> +
> static const struct qcom_reset_map lpass_tcsr_sc8280xp_resets[] = {
> [LPASS_AUDIO_SWR_TX_CGCR] = { 0xc010, 1 },
> };
> @@ -33,6 +53,9 @@ static const struct qcom_cc_desc lpass_tcsr_reset_sc8280xp_desc = {
>
> static const struct of_device_id lpasscc_sc8280xp_match_table[] = {
> {
> + .compatible = "qcom,sc8280xp-lpassaudiocc",
> + .data = &lpass_audio_csr_reset_sc8280xp_desc,
> + }, {
> .compatible = "qcom,sc8280xp-lpasscc",
> .data = &lpass_tcsr_reset_sc8280xp_desc,
> },
Johan
