On 5/10/23 18:26, Guntupalli, Manikanta wrote:
Hi Maarten,
-----Original Message-----
From: m.brock@xxxxxxxxxxxxx <m.brock@xxxxxxxxxxxxx>
Sent: Thursday, May 4, 2023 5:52 PM
To: Guntupalli, Manikanta <manikanta.guntupalli@xxxxxxx>
Cc: gregkh@xxxxxxxxxxxxxxxxxxx; robh+dt@xxxxxxxxxx;
krzysztof.kozlowski+dt@xxxxxxxxxx; michal.simek@xxxxxxxxxx; linux-
serial@xxxxxxxxxxxxxxx; devicetree@xxxxxxxxxxxxxxx; linux-
kernel@xxxxxxxxxxxxxxx; jirislaby@xxxxxxxxxx; linux-arm-
kernel@xxxxxxxxxxxxxxxxxxx; Simek, Michal <michal.simek@xxxxxxx>; git
(AMD-Xilinx) <git@xxxxxxx>; Pandey, Radhey Shyam
<radhey.shyam.pandey@xxxxxxx>; Datta, Shubhrajyoti
<shubhrajyoti.datta@xxxxxxx>; Goud, Srinivas <srinivas.goud@xxxxxxx>;
manion05gk@xxxxxxxxx
Subject: Re: [PATCH 0/2] Add rs485 support to uartps driver
Manikanta Guntupalli wrote 2023-04-26 14:29:
Add optional gpio property to uartps node to support rs485 Add rs485
support to uartps driver
Manikanta Guntupalli (2):
dt-bindings: Add optional gpio property to uartps node to support
rs485
tty: serial: uartps: Add rs485 support to uartps driver
.../devicetree/bindings/serial/cdns,uart.yaml | 5 +
drivers/tty/serial/xilinx_uartps.c | 96 ++++++++++++++++++-
2 files changed, 100 insertions(+), 1 deletion(-)
Why would you want to use a GPIO and not RTS for choosing the direction as
is more common in this case?
In ZynqMp platform Cadence UART Controller RTS signal routed to external through the PL(Programmable Logic) design not through Multiplexed IO.
Just to extend this a little bit. Cadence IP has modem signals but they are not
available over MIOs only over EMIO via PL logic. But board which this feature
targets can't have connection to PL pins to be able to use any modem signal for
this logic.
Thanks,
Michal
